搜索资源列表
sigle-KEY
- 基于stm32f103c8t6单片机的独立按键源码,固件库为3.5版本-Independent key source of stm32f103c8t6 microcontroller-based firmware library version 3.5
SingleKey
- AVR mega单片机使用独立按键来控制数码管程序-AVR mega microcontroller using a separate button to control digital tube
qdq
- 一个非常简单的抢答器,通过51开发板的独立按键操作,利用C语言编写-A very simple answer in 51 the independent key operation of the development board, using the C language
Static-digital-tube-display
- 该程序为数码管静态显示程序。 每按一次 独立按键 中的 T0,数码管的值便会加一。-The program for static digital tube display program. Each time you press the T0 independent keys, the value of the digital tube will add one.
yl236dulianjian
- YL-236 独立按键实例程序。亚龙-236实训台数码管独立按键C语言程序。功能完全符合比赛要求。-YL-236 independent key examples of procedures
DULIANJIAN
- C51 C52单片机简易程序之独立按键代码-C51 C52 microcontroller summary of the independent key code
key
- keil软件独立按键程序,用来驱动和检测独立按键,主要用于89c52单片机-keil
button
- 单片机外接独立按键长按和短按功能,使用汇编语言实现不同的功能。-Microcontroller external independent key long press and short press the function, the use of assembly language to achieve different functions.
anjian
- 属于verilog HDL程序,三个独立按键控制多位数码管显示三个不同的状态,已在FPGA板上验证过-failed to translate
fanghen
- MCU为整个系统的核心,控制着整个系统的运行,让MCU稳定的运行是非常必须的,MCU原理图如图2.2所示。MCU控制部分主要由STM32F103RBT6、晶振电路、复位电路、启动模式选择电路、独立按键电路以及LED指示组成。电源部分包括一个后备电源BAT1,一个主电源VCC3.3和一个模拟电源,模拟电源通过从VCC3.3加LC滤波电路得到。-MCU as the core of the entire system, controls the operation of the system as
tabnum
- 51单片机的一个控制程序,用C程序编写,功能是将按键次数写入AT24C08,再读出并用1602LCD显示,实验控制:按独立按键 K5键 数值加一 到99后 重新再从1开始:-One of the 51 single-chip control procedures, written in C program, function keystrokes write AT24C08 read out 1602LCD experimental control: independent keys K5 ke
PWM
- AT89s51 单片机 独立按键控制可调PWM波-AT89S51 microcontroller independent adjustable button control PWM wave
test1
- C51开发板,按下独立按键以后,使LED灯移动。-C51 development board, press the button after independence, the LED lights move.
independent-of-the-keyboard
- 这个程序是独立键盘的程序,想要学习独立按键的可以下载参考一下。-This program is independent of the keyboard program, you want to learn to be independent keys can download the reference.
anjiensm
- 通过独立按键可以实现相对应的数码管的数字-Keys can be achieved through separate digital tube corresponding figures,
123
- LCD1602、AT89C51、ADC0809、数字电压表、串口通信、独立按键 基于89C51交流电力智能传感器系统设计-LCD1602, AT89C51, ADC0809, digital voltmeter, serial port communication, independent buttons Based on 89 c51 ac power intelligent sensor system design
1.key_led
- C8051F320单片机按键例程,通过一个独立按键(接P0.0)控制7盏led灯的亮灭(按下即为0,led灯亮,反则灭)-C8051F320 MCU button routines, through a separate button (connected P0.0) control 7 led lamp light off (press is 0, led lights, anti then destroy)
CAN
- can通讯,采用can的回环模式,开发环境是keil,程序采用独立按键控制。-can communicate using the loopback mode can the development environment is keil, the program uses independent control buttons.
PCserial-communication
- 设计一个与PC串口通信的实验系统,当在PC机上输入十进制数时,可在实验板上显示相应的十六进制数字,而在实验板上按下独立按键A时,在PC机上也可以显示其对应的管脚数56。-Design an experiment with the PC serial communication system, when the PC input decimal number, you can experiment on-board display the corresponding hexadecimal num
51Pressbutton
- 51单片机程序,首先,在点阵的中间显示一个点。当您按独立按键的上下左右的时候,点阵会随之移动-51 SCM procedures, first of all, in the middle of the dot matrix display a point. When you press the up and down keys independently when the dot moves with