搜索资源列表
DS18B20temperaturesensor
- DS18B20 温度传感器读数据源程序 系统由中央控制单片机、温度检测器、时钟系统及显示器部分组成。控制器采用单片机AT89C51,温度检测部分采用DS18B20温度传感器,时钟系统用LED作为显示器。 单片机对数据处理后显示时间;温度传感器DS18B20采集温度信号送该给单片机处理,再把时间数据和温度数据送七段LED显示器显示,该系统还具有限温控制,当温度高于或低于某一给定温度值时分别有红灯和绿灯点亮提示,并伴随着蜂鸣器声音提示。本系统同时具有调节高低温上下限,时间调节功能-DS18B20
16X16led
- 1. LED的显示原理: 16×16扫描LED点阵的工作原理同8位扫描数码管类似。它有16个共阴极输出端口,每个共阴极对应有16个LED显示灯,所以其扫描译码地址需4位信号线(sel0-sel3),其汉字扫描码由16位段地址(l0-l15)输入。 通过时钟的每列扫描显示完整汉字。 2. 本试验实现输出“欢迎光临”四个汉字,采用两种格式输出:(1)依次从右向左连续输出;(2)单个汉字从上及下刷新输出。 -1. LED display Principle: 16 × 16 dot mat
mimasuo
- 电子密码锁,有掉电报存功能,能修改密码,LED显示屏显示,按键扫描-Electronic code lock, a cable kept out function, can modify the password, LED display screen, keypad scanning
123
- led显示 小键盘 8255附带 单片机工作原理 直接原文抄都行 图文附带-led display 8255 attached to a small keyboard working principle of single-chip are directly copied from the original graphic fringe line
LED
- 由于普通LED点阵显示屏动态显示通常采用硬件扫描驱动,这在一些需要特殊显示的场合显得不够灵活。文中提出了一种利用PC机和单片机的通讯来实现显示屏灵活的动态显示和远程监控的设计方法,同时该方法还可以将显示内容在PC机上进行预览。-LED dot matrix display as a result of the general dynamic display hardware used to scan drives, which require special display in a numbe
Radar
- 倒车雷达led显示器驱动程序,已经调试通过!-Reversing radar led display driver has been debugging through!
led
- 单片机控制LED显示的命令语句,简洁明了。可用vw仿真器调试-Single-chip LED display control command statement, clear and concise. Debugging emulator is available vw
s3c2410-double-led
- 基于ARM,s3c2410的led显示程序,可实现8位数码管的显示,可控制任意数码管点亮与关灭。-Based on the ARM, s3c2410 the display program led to the realization of an 8-bit digital tube display, can be controlled with any clearance digital tube lights out.
LED
- 这是一个用VHDL编写的LED显示程序,该程序虽然简单,但对一个初学的人来说也未必用不到,所以上传,希望能有人用到-This is a VHDL prepared with LED display program, the program is simple, but for a beginner who may not be less than, so upload the hope was to use
8279keyled
- 使用8279连接键盘和LED,由键盘输入,在LED显示器上显示相应数字,单片机采用51系列-Use 8279 to connect the keyboard and the LED, by keyboard input, in the LED display to show the corresponding figures of 51 series single-chip
traffic
- 一个很好的交通灯控制的Verilog HDL实现方式,包括LED显示部分。-A good control of traffic lights to achieve the Verilog HDL, including the LED display.
LED-time
- 功能: 简易带有百位毫秒显示的24小时制时钟 8个数码管从左至右依次显示:时,分,秒,-,百位毫秒。 显示格式: 01. 23. 45. - 6 程序中有内部RC振荡效准功能。 -Function: 100 ms with a simple display of a 24-hour clock system 8 digital tube display from left to right: hours, minutes, seconds,-, 10
LED-Dot-Matrix-Display
- this is led dot matrix
LEDVHDL
- 8.2 LED控制VHDL程序与仿真 本节分别介绍采用FPGA对LED进行静态和动态显示的数字时钟控制程序。 1. 例1:FPGA驱动LED静态显示 --文件名:decoder.vhd。 --功能:译码输出模块,LED为共阳接法。 --最后修改日期:2004.3.24。 -8.2 LED control and simulation of VHDL procedures introduced in this section of the LED using FPGA st
led-int
- 利用单片机的定时器以及中断的方法的LED灯显示程序。-The use of single-chip timer and the method of interruption of LED lights display program.
Congzhan
- 用于控制二相步进电机驱动运作,LCD显示,LED显示,而含PID算法。-Used to control two-phase operation of stepper motor driver, LCD display, LED display, and with PID algorithm.
Display
- 8051 LED Matrix Routines
IDRHEWH
- LED显示4个汉字,并且实现汉字在LED上的左移程序-LED display four characters, and the realization of Chinese characters on the left in the LED process
2ADC0809-LED
- ADC0809 摸数转换 LED显示 8051C源程序-Digital converter ADC0809 touch 8051C source LED display
pinlji
- 同样是基于altera芯片的简易频率计程序!!用数码管显示-Similarly, based on the simple altera-chip frequency counter program! ! Digital LED display! ! !