搜索资源列表
RT3-electronic-thermometers-source
- RT3电子温度计源程序,STC12C5A60S2系列 12MHz晶体,每1分钟左右更新一次温度数据,采用单片机空闲模式,LM75掉电模式。-RT3 electronic thermometers source, STC12C5A60S2 series 12MHz crystal, updated once every 1 minute or so the temperature data, using SCM idle mode, LM75 power-down mode.
LM75_test
- 51单片机 I2C通讯案例(LM75温度芯片)-51 single I2C communication scenarios (LM75 temperature chip)
lm75
- 温度传感器的VHDL实现,可以实现对温度的测量,基于赛克隆4芯片实现-温度传感器的VHDL实现,可以实现对温度的测量,基于赛克隆4芯片实现 The temperature sensor VHDL, can realize the measurement of the temperature, season 4 chip based on cloning
lm75
- 基于cortex_a8的温度采集模块驱动源代码-Based cortex_a8 temperature acquisition module driver source code
ARM8962-Programe
- arm8962 IO 与 延时 的演示,出厂演示程序实验按下 KEY1 时,LED3 灯亮、按下 KEY2 时,LED4 亮、按下 KEY3 时,LED5 亮;按下 KEY4 时,LED6 亮,蜂鸣器每隔一段时间鸣叫两声,LED1 和 LED2 也会每隔一段时间闪烁两下,CPU 会读取 LM75 的温度和电位器 W2 的电压通过串口发送 到 PC 机的串口终端上去
I2C-test-4
- Temperature sensor lm75 with stm8s
lm75
- Linux kernel modules for hardware monitoring.
lm73
- LM73 Sensor driver Based on LM75.
Character-device-drive
- 字符设备驱动,按键驱动字符驱动,包含了按键、led、pwm、adc、lm75的驱动-Drive character drive character device driver, buttons, contains buttons and leds, PWM, adc, lm75 driver
windfarm_lm75_sensor
- Windfarm PowerMac thermal control. LM75 sensor.
pdf-LM75
- LM75AD temperature sensor datasheet
I2C_LM75A
- stm8s LM75驱动程序模拟IIc,移植方便可直接使用-stm8s LM75
RT3
- 第1 步 焊接LM75 将LM75 如上图的样子放在单片机的第21 到23 脚上。 将LM75 芯片的第1 至4 脚如上图焊接在单片机上面,注意2、3 脚合在一起焊接。 剪一段普通直插电阻的引脚,把LM75 另一边的第5 至8 脚焊接在单片机(First step welding LM75 Put the LM75 as shown above on the twenty-first to 23 feet of the microcontroller. The LM75 chip fi