搜索资源列表
beep_example
- at91sam9g20芯片开发下 蜂鸣器驱动-at91sam9g20 under the buzzer driver chip development
at91_can4linux-3.5.3
- AT91SAM9G20开发板上面蜂鸣器的linux设备驱动程序-AT91SAM9G20 development board above the linux device driver buzzer
at91_beep
- AT91SAM9G20开发板上面蜂鸣器的linux设备驱动程序-AT91SAM9G20 development board above the linux device driver buzzer
Beep_music
- 44b0 ads环境下的源代码,利用蜂鸣器播放音乐程序,-44b0 ads source code environment, the use of the buzzer music program
MCS-51
- 用单片机实现温度测量,所测温度显示在LED上并且温度过高时会自动报警,报警用蜂鸣器来实现。-With MCU temperature measurement, the measured temperature displayed on the LED and alarm automatically when the temperature is too high, to achieve the alarm with a buzzer.
sing
- 利用 定时器和蜂鸣器唱歌,经过本人测试,程序可正常工作,并发出指定歌曲声音-By using the timer and buzzer to sing, after I tested, the program can work, and issued the specified audio song
Timer_Beep_V2.1_OK
- 芯达STM32开发板的定时器和蜂鸣器测试程序,希望对大家有帮助。-STM32 development board core of the timer and buzzer test program, we want to help.
buzzer_test
- 蜂鸣器测试程序,比较设和嵌入式的入门者做学习参考,也可以作为开发人员参考-Buzzer test program to compare the beginners set and embedded learning to do reference can be used as reference for developers
TPQDQ
- 基本要求: (1)通过功能切换开关设定为抢答功能,完成4人抢答功能,通过启动按键启动抢答,数码管显示抢答到计时,抢答成功后,到计时停止,蜂鸣器响,抢答成功的键盘对应的指示灯亮。 (2)通过功能切换开关设定为投票功能,完成4人对4候选人投票功能,通过启动按键启动表决,数码管显示投票倒计时, 4个LED指示灯闪烁,计时到零,4个LED指示灯灭,从1到4轮番显示表决结果,第一个数码管显示候选人编号,第二个数码管显示该候选人得票数。 扩展要求: (1)通过串行口将抢答信息、时间信息和投票
CortexM3basedstarsUCOSIIportableuseoftemplates.RAR
- 基于群星Cortex-M3的μCOS-II移植模板的使用 基于群星Cortex-M3的μCOS-II移植模板的使用.pdf 介绍了基于KEIL和IAR两种编译器模板的使用 移植模板 基于IAR 5.11的μCOS-II移植模板 例子程序 基于IAR 5.11的LED和蜂鸣器的实验程序 模板+例子 整合移植模板、LED、Buzzer-Cortex-M3-based stars μCOS-II portable use of templates Cortex-M3-based sta
music
- 将一个PC机的蜂鸣器改为电子琴,可以演奏歌曲,又可以播放歌曲。-A buzzer will be changed to PC-keyboard, you can play the song, but also can play songs.
SOUNDER
- ST套件产生报警音 本实例的目的是让大家学会用单片机产生声音的方法,学会计算程序所用时间 本实例的功能是能PIC16F84产生报警音,频率分两个0.1s第一个 0.1S频率从1.8K-3.5K匀速增加第二个0.1S频率从3.5K-1.8K匀速减少, 程序复位后,蜂鸣器开始报警 PIC单片机学习网-----http://www.pic16.com 烧写时应注意:配置位已经在程序中写明,加载HEX文件时会自动加载,烧写时不用再手动设置配置位。 实验时
BELL
- YM100实验指导,BELL蜂鸣器C语言程序参考。-YM100 experimental guide, BELL Buzzer C language program for reference.
33666
- 8个发光管由上至下间隔1s流动 其中每个管亮500ms,灭500ms,亮时蜂鸣器响 灭时关闭蜂鸣器,一直重复下去。-8 LED top-down flow of the interval in which each tube light 1s 500ms, OFF 500ms, lit off the buzzer when the buzzer off, has been repeated down.
music
- 用汇编语言编写的音乐播放,程序烧写到芯片后,在板上如果有蜂鸣器,上电复位后可以听到一首歌曲播放。-Written in assembly language of music playback, programmed into the chip, if the board buzzer, reset on a song can be heard after the play.
shizhong
- DS1302 LED 定闹钟 修改日期年份 六位LED数码管显示 配合蜂鸣器 带备用电源考非得要二十个字-DS1302DS1302 LED alarm clock modified LED digital display of six years with the buzzer with a standby power test have to be twenty words
3.DS18B20Temperaturesensor
- DS18B20精确到0.1度,有proteus和PCB,可以设置上下限温度,蜂鸣器输出。-DS18B20, accurate to 0.1 degrees, proteus and PCB, can set upper temperature, buzzer output.
Examples_w_uCOS-II
- ucosII程序移植相关例程,蜂鸣器控制,调制实验,串口控制实验等-ucosII routine transplantation procedures, buzzer control, modulation experiment, serial control experiments
C51_Beep_music
- 利用STC89C52+C语言所写的一个利用蜂鸣器发声的音乐播放器。-STC89C52+ C language written by a buzzer sound using the music player.
fengmingqi
- atmega16驱动蜂鸣器唱歌程序-atmega16 driver buzzer singing program. . . . . . . . . . . . . .