搜索资源列表
CTC 解码算法
- This platform simulates the classical turbo encoding-decoding system, including Log-MAP algorithm and max-log-MAP algorithm.
pwm_ctc.rar
- 基于ATmega16的CTC PWM的一段小程序。,ATmega16-based section of the CTC PWM applet.
20090927
- mega48的一段程序,利用CTC长生300Khz的占空比为50 的方波-code for mega48,use CTC mode to perform square
50HZ
- 利用ATMEGA16定时/计数器的比较匹配输出性能,在CTC模式下,,产生50HZ 左右,占空比为50 的方波.-ATMEGA16 use timer/counter output compare match the performance, in CTC mode, 50HZ have about 50 duty cycle square wave.
ctcoffenpin
- 利用ctc模式产生分频器。用atmega16单片机。有proteus仿真/。-Crossover use of patterns ctc. Single-chip microcomputer with atmega16. There proteus simulation /.
ctc_sim_tb
- CTC 测试文件 standard_sim_tb-CTC test file standard_sim_tb
standard_sim_tb
- xilinx CTC IPcore(encoder 和 decoder）的标准测试，未经信道加噪-the standard test of xilinx CTC IPcore (encoder and decoder) , without the channel with noise
hwitl_sim
- xilinx CTC IPcore(encoder 和 decoder)的测试，经过AWGN信道。 -This simulation uses a AWGN module to include noise as part of the simulation. Prior to running the simulation, the UniSim models for the encoder and decoder must be generated as well as the AWGN
ctc_advanced_sim_tb
- xilinx CTC IPcore 误码率测试-xilinx CTC IPcore Bit Error Rate Test
CTC_EPON_test_200704
- 中国电信epon产品测试方案,2007年版-China Telecom epon Test Solutions
003-BUZZ
- 驱动无源蜂鸣器实验。 1、定时器实验，用定时器的CTC模式驱动无源蜂鸣器，是否输出由按键0控制。 2、内部1 M晶振，程序采用单任务方式，软件延时，驱动无源蜂鸣器由定时器硬件完成。 3、进行此实验请插上BUZ短路块。 4、此实验让大家了解定时器里面的CTC功能，从而可以利用它来产生频率信号。-Driven passive buzzer experiments. 1, timer experiment, using the CTC timer mode driver pas
CTC-Hanliu
- 这个是wap开发的工程,可以调试使用,是个比较完整的程序-This is wap development project, you can debug use, is a relatively complete process
router
- 自己提交的某硬件路由上的路由表,cnc和ctc全部最新.很方便路由管理员,vpn,和s5代理开发者.-Their submission of a hardware routing the routing table, cnc and ctc all the latest.
ctcENCODERtest
- 802.16标准中定义的卷积turbo码的编码实现，交织，循环状态等可参见802.16e.-Defined in std 802.16e, the encoder of CTC is put into practice with VC. In addition, interleaving and circular state can be found with reference to std 802.16e
testPWM
- ATmega16单片机的PWM和CTC的波形产生实例，可以供应用-ATmega16 microcontroller and PWM waveforms generated instances of CTC, can supply with
WIMAX_Turbo_Code
- 这是一套完整的支持wimax 16e协议CTC的编译码程序， 主程序在demo.c 译码器：tcdecoder.c 编码器：tcencoder.c-/* This program simulates the classical turbo encoding-decoding system on PC.*/ /* It uses parallel concatenated convolutional codes described in Figure 2.9 in Chapter
ctc_decoder_pdf
- CTC编码详细介绍, -the introduction of CTC
CTC_DEC
- 使用m语言完成的关于CTC（Convolutional Turbo Code）编码方案-CTC decoding algorithm
fangbo
- 基于M16的100HZ-1MHZ的方波频率发生器 利用M16 TC1的CTC模式产生方波，为使频率精确，本例使用了外接晶体7.3728M，能产生的最高频率为1.8432M，最低频率为57HZ。本例选用100HZ-1MHZ（999.9KHZ）范围。-M16' s 100HZ-1MHZ based square wave frequency generator using the CTC model M16 TC1 produce a square wave, for the freque
yejingxianshiPCTC
- 产生2Mhz方波信号，是atmega16的CTC模式产生，作为AD9059的时钟信号。还有12864液晶波形显示程序（含液晶驱动）-2Mhz square wave signal generated is atmega16 produced in CTC mode, the clock signal as the AD9059. There are 12864 LCD waveform display program (including LCD driver)