搜索资源列表
数据分析入门
- Udacity数据分析纳米学位课程代码,ipython notebook打开(Udacity nano lesson code)
FreqSweep
- 此程序用于arduino板(nano,其他可适当修改引脚),MCU采集信号发生器的波形,然后再输出同等频率的互补方波,主要用于驱动全桥或半桥逆变电路,可作为电力电子电路驱动信号扫频。 信号发生器采集引脚:D4 输出方波引脚:D9和D10(This program is used for Arduino board(nano,also can be modified for other types). MCU collect waveform from signal generator,th
face
- 系统介绍:基于树莓派官方系统stretch 系统,系统内安装了opencv3.3.0以及 tensorflow1.1.0 。人脸识别门禁的代码在里面目录/home/pi/face。内安装了深度学习的案例。 程序启动说明:开机前连接树莓派摄像头或网络USB摄像头,网络摄像头无需下面的设置。如使用树莓派摄像头则在终端输入 sudo nano /etc/modules-load.d/modules.conf 在最后添加一行添加 bcm2835-v4l2 ctrl+O回车保存 ctrl
blue-app-btc-master
- btc coin开发示例,需要nano s固件(btc coin demo,need nano s firmware)
800px-Bluepillpinout
- arduino pin out diagram
nRF24L01pScannerOled
- 用来监测周围2.4GHz无线环境,显示信号所在频率及强度,扫描和显示范围是2400MHz-2510MHz。(It is used to monitor the surrounding 2.4GHz wireless environment, show the frequency and intensity of the signal, and scan and display range is 2400MHz-2510MHz.)
Biofilms_Module_Archive
- parallel code for a biofilm
Arduino端控制程序
- 六自由度 Servo机械臂 Arduino nano控制程序(Arduino nano control program for six degrees of freedom Servo manipulator)
topological insulator in GaN_InN quantum well
- 改代码能够计算GaN_InN 量子阱内的能带结构,该体系为拓扑绝缘体体系,能够计算基本的 能带结构,电子密度分布,边沿态等。。 参看文献: [1]. Dan M, Hu G, Li L, et al. High Performance Piezotronic Logic Nanodevices Based on GaN/InN/GaN Topological Insulator[J]. Nano Energy, 2018. [2]. Miao M S, Yan Q, Van de Wall
UniSolder-5.2C
- UniSolder-5.2C 俄罗斯开源(UniSolder-5.2C A short list of features: - power: 12-24V, AC or DC (24V 6A toroidal transformer is the best possible power source) - automatic 1/2 and 1/4 power selection, so only simple single winding 24V can drive all the ins