搜索资源列表
BMP085-IIC-test
- 基于STM32103ZET6的BMP085(I2C协议通信气压温度模块)的测试代码-Based STM32103ZET6 the BMP085 (I2C protocol communication pressure temperature module) test code
bmp180
- BMP180 气压传感器 C51下驱动,包括 温度 气压 的读取 修正 海拔高度的计算。-BMP180 pressure sensor of C51 under the driver, including temperature pressure reading corrected altitude.
STM32F4BMP08
- 读取温度和气压的程序模块,采用STM32F4X处理器的IIC总线-Read the temperature and pressure of the program modules, using STM32F4X processor IIC bus
bmp180driver
- BMP180是一个I2C总线的气压传感器,本代码根据AT24C08的驱动程序改编。在mini2440开发板上测试可用。-BMP180 I2C bus is a pressure sensor, the code based on AT24C08 driver adaptation. In mini2440 development board test available.
STM32_MS5611
- STM32测试气压计MS5611的代码,通过串口回传气压数据。基于KEIL软件。-STM32 barometer MS5611 test code, return air pressure data via the serial port.
main
- STM32下的sht25读取温度、湿度、气压的程序,应用于气象数据采集及相关的环境数据采集方面-Sht25 under STM32 read the temperature, humidity, pressure procedures used in meteorological data acquisition and related environmental data collection
OLEDPBMP180-ok
- OLED12864 屏显示气压传感器数据-OLED12864 screen display pressure sensor data
BMP085
- 气压高度传感器BMP085的驱动程序,在STM32平台上调试通过。-Pressure altitude sensor BMP085 driver on STM32 platform debugging.
qiyaATmega328
- 基于ATMEGA328的气压传感器的应用-Based on the application of pressure sensors ATMEGA328
GY-65
- 基于51单片机的GY-65气压传感器模块串口通信,液晶显示源程序及模块引脚接线图-Display based on 51 microcontroller GY-65 pressure sensor module serial communication, LCD source code and module pin wiring diagram
GY-65-AVR
- 基于AVR单片机的GY_65气压传感器模块通信程序-AVR microcontroller based GY_65 pressure sensor module communication program
GY-80_STM32
- 基于STM32芯片的GY-80九轴数字陀螺仪及气压传感器模块串口通信程序-Based STM32 chip GY-80 nine-axis digital gyroscope and pressure sensor module serial communication program
gy65
- gy65 气压测量模块,并在12864显示-werr dgeg gegr gsertg
BMP180
- 博世传感器气压传感器BMP180的驱动程序,C程序源代码-Bosch sensor pressure sensor BMP180 drivers, C code
Arduino-0.22-MS561101BAOK
- 基于Arduino对气压传感器MS5611的(精密修正)数据采集-Arduino based on MS5611 pressure sensor (precision correction) data acquisition
denggaoxiantu2D
- 对采集到的回转窑的大数据,绘制出窑体温度与气压的等高线图,通过图形可以分析,窑体工况-Large data collected kiln, draw contour map kiln temperature and pressure, can be analyzed through a graphical, kiln conditions
bmp180-read-and-write-program-code
- bmp180数字气压温度传感器读写程序。效果非常好,测量结果非常准确。-bmp180 digital temperature sensor pressure literacy program. The effect is very good, very accurate measurements.
compare_diff_RO
- 不同数据处理中心GPS掩星数据产品的比较,例如折射率,温度,气压-Comparative data of different products occultation data processing center GPS, e.g. refractive index, temperature, pressure, etc.
STM32F103RF24L01
- 24l01无线收发程序,基于stm32f103,带彩屏显示 ,里面还有汉子显示,气压读取发送-24l01 radio program, based on stm32f103, with color display , There is also man show, pressure reads send
BMP180daima
- 基于单片机的气压采集程序,通过相应的改写就可以使用,简单易懂-Pressure acquisition program based on single chip microcomputer,through the corresponding rewrite can use, easy to understand