搜索资源列表
maichongceliang
- 对于已获得的脉冲包络采样序列,需测量的脉冲特征参数主要有:脉冲幅值(PA)、脉冲到达时间(TOA)和脉冲宽度(PW)。实际测量中,脉冲波形的形状是各种各样的,但其主要的参数有脉冲幅度、脉冲宽度、脉冲周期、脉冲占空比、脉冲前沿(上升时间)、脉冲后沿(下降时间)、脉冲上冲、脉冲下冲、脉冲下垂、脉冲顶部不平度等,脉冲参数的计量主要就是对这些参数进行计量。本程序包实现基于FPGA实现脉冲宽度和重复周期的测量。-Who have access to the pulse envelope sample se
Flower
- 利用单片机定时器中断,通过按键控制定时器计数初值,从而调节程序进入定时器中断的频率,实现输出不同频率的脉冲信号,使蜂鸣器发出不同频率的声音~~简单有趣-Interruption of the use of single-chip timer, the timer counts through the buttons to control the initial value, thereby regulating the procedure to enter the timer interrupt
maiya
- ex9_12 二相编码信号的脉压处理,13位巴克码用于雷达的二相编码脉冲压缩中,由于巴克码具有好的自相关函数,所以其脉压结果很好-BPSK ex9_12 pulse pressure signal processing, 13 Barker Code for the two-phase coded radar pulse compression, as a result of Barker codes have good auto-correlation function, so its a v
lfm
- 关于lmf算法的论文,用高速DSP在频域上实现LFM信号的实时脉冲压缩-Lmf algorithm on paper, using high-speed DSP in the frequency domain to achieve real-time signal LFM pulse compression
DM1_KEYs_LEDs_C5T
- FPGA的键盘和LED显示。详细情况可用QuartusII打开,了解顶层原理图上的文字标注。键1控制计数脉冲,计数显示于数码管和发光管。-the file succeed in making the LEDs changed according to our key.
beipin
- 倍频出200M时钟,对输入脉冲进行计数测量时间间隙-produce 200M clock,count the input pulse
StepperMotorControllers
- 以单片机为内核的小功率步进电机速度控制器。单片机接受来自RS232的速度控制指令,通过单片机转换成步进电机的走步脉冲,同时对2只步进电机的连续速度控制。要求讨论速度与走步脉冲的关系,并实现加速、减速和恒速工作。-SCM as a core with low power stepper motor speed controller. Microcontroller to accept the speed control commands from the RS232, through the mi
signalprocess_radar
- 雷达信号处理部分,包括正交相干检波、脉冲压缩、多普勒处理和恒虚警检测。-Radar signal processing parts, including the quadrature coherent detection, pulse compression, Doppler processing and CFAR detection.
MCU_measuring_motor
- 51单片机测量电机转速,利用计数脉冲数显示到汉字液晶屏上面。脉冲是由对管扫描码盘产生的-51 MCU measuring motor speed using pulse-counting the number of
maichongcotrol
- 此程序主要用于复杂动态网络脉冲控制实现同步的方法,对于研究复杂网络同步有帮助。-This procedure mainly uses in the complex dynamic network pulse control realization synchronization the method, has the help regarding the research complex network synchronization.
XcorrGauss
- 生成高斯波形脉冲,并求解高斯脉冲的自相关结果-Gaussian pulse waveform is generated, and solve the results of Gaussian pulse autocorrelation
smartNoise
- 灵巧噪声干扰,可针对脉冲压缩雷达和PD雷达,具体干扰样式有:三角波调频干扰信号 锯齿波调频干扰信号 马鞍型噪声干扰信号 噪声调相干扰信号 噪声调频干扰信号.-Smart noise interference may be directed to pulse compression radar and PD radar, specifically jamming style are: triangle-wave frequency modulation interference signal s
mcu0
- 本论文详细讲述了如何用查询法实现单片机对多路低频脉冲信号的采集!-it has demostrated how to use MCU to sample data!
maichongsin2
- 该程序实现了基于小波模极大值去噪算法,并有效的去除了信号中的脉冲噪声。-The program achieved a de-noising based on wavelet modulus maxima algorithm, and effectively removes the signal of the impulse noise.
EliminateGlitch
- 通用消除窄脉冲和最大脉冲宽度判断,用于防止外部干扰导致通讯异常,硬件EMC等-GM to eliminate narrow pulses and maximum pulse width to determine, for the prevention of external interference caused abnormal communications, hardware, EMC, etc.
LFM_radar_simulation
- 文件中包含word文档报告 设雷达采用匹配滤波完成脉冲压缩,采集频率fs=420MHz,仿真雷达回波,并绘出家Hamming窗前后的脉压波形。(提示:通过正确设定采集波门,减少数据量) 设雷达采用Dechirp方式完成脉冲压缩,其中参考距离位于(0,0),采集频率为10MHz,距离采样点数512点,仿真雷达回波,并绘出加Hamming窗前后的脉压波形(提示:通过正确设定采集波门,减少数据量)。-Word document file contains the report of the
SAR_LFM
- 关于合成孔径雷达信号的基础知识和如何进行线性调频脉冲信号的压缩及其matlab源码。-Synthetic aperture radar signal on the basis of knowledge and how to carry out a linear FM pulse compression and the matlab source code.
SAR1
- 雷达采用匹配滤波完成脉冲压缩,采集频率fs=420MHz,仿真雷达回波,并绘出加Hamming窗前后的脉压波形。目标如图所示由(-5,-2),(0,5)和(6,-7)三个散射点组成,散射强度分别为(1,2,5),雷达位于(-5000,0)处-The completion of the radar pulse compression using matched filtering, collecting the frequency fs = 420MHz, simulation of the ra
PCMcode
- 实现通信原理上的PCM(脉冲编码调制)调制与解调等 功能-MATLAB PCM
Chirp_Pulse_Comp
- chirp信号脉冲压缩,用于雷达信号处理,产生chirp信号后进行压缩,以实现高距离分辨力-chirp signal pulse compression for radar signal processing to generate chirp signal is compressed in order to achieve high range resolution