搜索资源列表
MEGA16
- MEGA16和L298驱动两路电机的程序 通过测试-MEGA16 and L298 two-way motor-driven process by testing! ! !
moto
- 带有仿真文件 步进电机的pwm控制 采用L297&L298芯片 1602实时显示电机转速-Simulation file with pwm stepper motor control chips used L297 & L298 1602 real-time display motor speed
ewqe
- 采用L298芯片做成步进电机驱动电路。最大电流可以输出2A。-Made by L298 chip stepper motor driver circuit. Maximum current to the output 2A.
control
- 用L298控制直流电机加减速的89c51单片机C程序 -DC motor with L298 control acceleration and deceleration of 89c51 microcontroller C programs
CHENGXU
- 单片机控制减速电机通过PWM控制电机转速左右转向。驱动芯片为L298.-Geared Motor Controlled by PWM control of motor speed towards you. Driver chips for the L298.
stc_l298
- STC单片机控制L298驱动两个直流电机。-dcmotor drive
yinyuepenyuan1
- 利用mega16单片机和L298实现音乐喷泉的控制-SCM and L298 using mega16 control of music fountain
soccorrobo
- SOCCER-ROBOT DESIGN ON FPGA source code. The robot is triangle width 20 cm. height 15 cm. have 3 motor and control by L298 chip.
ATMEGA16andL298
- 实用程序代码，凌阳61板试验可行，适合L298芯片的学习-Utility code, Sunplus 61 board test method is suitable for L298 chip learning
drivestepmotorbyL298L297
- 通过L298,L297对步进电机实现正反控制，并且能用数码管记录时间-By L298, L297 on the stepper motor to achieve positive and negative control, and recording time can use the digital control
CAR
- 用于MSP430单片机的L298芯片控制直流电机源代码-L298 chip MSP430 MCU for control of DC source
PWM
- 写的程序为pwm驱动直流电机 用的是L298驱动 并用四个按键 实现电机的速度变化 -Writing programs for dc motor using PWM driven by four buttons is L298 drive motor speed variation. Realizing
l297l298
- 本程序基于C8051F330，L297/298的步进电机驱动程序,P1.1 控制L297使能位ENBLE,P1.2 控制连L297 CCW口控制电机正反转-L297 L298 C8051
forward-reverse
- 实现智能小车的前进和后退动作，小车电机由L298驱动，本程序控制L298的三个输入端即可-complete a small car s forward and reverse action,power is supplied by L298
nrf901
- l298电机驱动芯片的详细资料，方便电机开发的人员学习。-l298 motor driver chip detailed information to facilitate the motor development to learn.
motor
- 电机控制程序。采用L298驱动，用AT89S52作为主控芯片，实现电机正反转的控制。-motor drive control
1
- 这是一个使用51单片机加上L298驱动直流电机的程序源代码。-This is a single chip using 51 L298-driven DC motor with source code.
DianJi
- 基于ARM的直流电机驱动，能正反转，停止启动，采用了L298作为驱动-ARM-based DC motor drive, to reversing, using the L298 as a driver
line
- 智能寻线两轮式小车，采用L298驱动，MCU为STC12C5A60S2-Hunt two-type car, with L298 driver, MCU is STC12C5A60S2