搜索资源列表
12
- 实显示采集到的心电波形信号,有SD卡存储和USB数据传输功能-Real display collected ECG signal, SD card storage and USB data transfer function
stm32f4-usb-msc-(sd-card)
- 板载了STM32F407ZE_LQFP144 @168MHz 以及一颗2MB SRAM(10ns)(很贵啊),主要是想用来跑emwin; 2.4GHz是留着和其他板联机的,目前第一个预留的是点阵控制卡以及... .-Onboard the STM32F407ZE_LQFP144 lqfp144 @168MHz and a single 2MB SRAM (10 ns) (very expensive) is mainly used to run the EMWIN 2.4GHz is rete
mkefidisk
- 在linux系统下,将嵌入式系统镜像文件,写入到存储设备中,以便开发板能顺利通过efi引导进入嵌入式操作系统。-You can write image to a USB key, SATA drive, or SD card using the mkefidisk.sh scr ipt.
M3_SDIOPUSBPFATFS.zIP
- STM32操作SD卡、FATFS,USB设备,SD卡操作通过SDIO接口-STM32 operation SD card, FATFS, USB device, SD card operation through SDIO interface
library
- 脱机打印,首先都是要把gcode文件放到SD卡上,方法一是在电脑的软件里选择SD卡上的文件开始打印,然后就可以拔掉USB线了(当然不拔也可以,随便你。);方法二是把要打印的gcode文件重新命名成init.g,放在SD卡的根目录下,重新启动打印机(按reset按键或者断电重新上电都可以),机器就自动开始打印init.g这个gcode了。-There are two ways for offline printing, first of all put gcode file on the SD c
Keil
- keil LPC4357开发板代码,支持驱动自动在线升级及cmsis, 文件系统,SD卡驱动,USB驱动.-keil LPC4357 Demo Board code, Support driver upgrade online and cmsis, file system sd card usb driver.
STM32_USB-Mass-Storage
- 本例程移实现SD卡虚拟U盘功能。本例程的源代码主要来自于ST的USB固件库中的范例。-This routine moves to achieve a virtual SD card U disk function. The source for the routine mainly ST' s USB firmware library paradigm.
stm32USB
- STM32通过USB外设将SD卡模拟成U盘,可以直接进行读取数据-STM32 via USB peripherals will be simulated SD card into USB flash drive, data can be read directly
PhotoDemon-master
- 一个很好的图像处理软件源码,很轻便,很小巧,在U盘就可以使用。-It provides a comprehensive selection of photo editing tools in an 8 MB download. It runs on any Windows machine (XP through Win 10 TP) and does not require installation. It can easily be run a USB stick or SD card. T
STM32F407-SDPUSB
- STM32F407 单片机同时挂载内存卡和U盘-STM32F407 mount sd and usb at the same time
USBCardReader
- miniSTM32+usb读卡器,实现电脑和SD卡的数据传输- MiniSTM32+ usb card reader,to achieve the computer and SD card data transmission
USB_PC_USB_SD
- 本软件利用STM32f407芯片操作SD卡和USB存储器,我已经测验了在STM32f407开发板,很有用的软件-This software uses the STM32f407 chip operation SD card and USB memory, I have tested in the STM32f407 development board, very useful software
EMB8616I工业测控板-V1.00-20150812
- uccos下的STM32的开发平台,可用于单片机系统开发,融合所有的驱动,并移植了fatfs(STM32+UCCOS+fatfs+tcpip+sd+usb+)
vold
- VOLD作为安卓加载外置存储设备的守护进程,其源码供各位参考(VOLD is a deamon for mounting sd card or usb devices in android system, it is the source code for reading.)
uImage
- 内核映像文件要求上传您自己觉得好的资料 本次上传日志请勿上传和编程无关的文件(Kernel image file(Patch file included in the kernel driver source code, including LED drivers, serial port driver, NIC driver, SD card driver, LCD, and USB drivers.))
CH375的库文件1
- ch375的库文件,供编程参考 有技术资料和51例程(CH375 library files for technical reference and C51 programming reference)
1_开发板例程_Ver2_1
- MM32开发板活动资料 1 个标准的 JTAG/SWD 调试下载口 1 个电源指示灯(蓝色) 2 个状态指示灯(DS0:红色,DS1 :绿 色 ) 1 个 IIC 接口的 EEPROM 芯片,24C08,容量 1024 字节 1 个 SPI FLASH 芯片,S25F008A,容量为 1M 字节(即 8M bit) 1 个标准的 2.4/2.8/3.5/4.3/7 寸 LCD 接口,支持触摸屏 1 个 OLED 模块接口(与 LCD 接口部分共用) 1 个
RASPI_WINXARM_qudong
- 用于树莓派3b和3b+运行微软windowsarm时候需要的sd卡,usb,cpu驱动(For raspberry pie 3b and 3b+ running Microsoft windowsarm SD card needed, USB, CPU drive)
emmc
- emmc协议的实现代码,包含了SD协议,usb实现协议(The implementation code of EMMC protocol)