搜索资源列表
FPGA-auto-car-and-arm
- VHDL Verilog编写,实现无线串口通信遥控4自由度机械臂和车身行动驱动。串口命令格式和舵机参数可根据实际需要自行调整-Verilog VHDL prepared to achieve a wireless serial communication remote control 4 degrees of freedom manipulator and body action. Serial command format and actuator parameters can be adju
chuanxing
- VHDL的串行通信程序,硬件描述语言,使用xilinx ISE软件-VHDL serial communication program
URAT
- 在ISE环境下,用VHDL语言实现RS232串口设计,实现串口通信。通过串口调试工具向 0000000UART发送16进制数,FPGA将UART接收到的串行数据转换为并行数据,并在8个 LED灯上输出显示;同时,并行数据又被重新转换为串行数据,重新送给RS-232接口,并在 串口调试工具上再次显示,SW0为复位键。 比如:串口调试工具发送两位16进制数,然后能在LED上显示,并且重新在串口调试工 具上显示。串口调试工具设置:波特率设为9600,默认奇校验。-In the IS
pc_fpga_com_latest.tar
- 用VHDL实现的PC与FPGA之间的网络通信,通过以太网进行通信-comunicate between PC and FPGA via ethernet
kehshechenxu
- 编制一全双工UART电路,通过试验箱MAX202E转换成RS232电平,与计算机进行通讯实验,设置8个按键,按键值为ASIC码“1”~“8”,通过串口发送给计算机,在计算机上显示键值,同时在数码管最高位显示;计算机可发送“0”~“F”的ASIC码,FPGA接收后在数码管低位显示0~F。通过按键可设置波特率。 要求:波特率为三种 1200、2400、9600,由1个按键选择,3个LED分别指示; 数据格式为1位起始位、8位数据位和一位停止位; 上位计算机发送接收软件可使用
RS422
- 基于vhdl开发的指令发送程序,实现RS422通信功能(instruction sending based on VHDL development)
HDB3
- 按照要求对“数字基带信号HDB3译码器设计与建模”进行逻辑分析,了解HDB3译码器译码原理,了解各模块电路的逻辑功能,设计通信系统框图,画出实现电路原理图,编写VHDL语言程序,上机调试、仿真,记录实验结果波形,对实验结果进行分析。(In accordance with the requirements of the logical analysis of the design and modeling of the digital baseband signal HDB3 decoder, H
rs232
- 使用VHDL语言在vivado平台上编的串口通信的完整工程,并能用EGO1开发板成功验证(The complete project of serial communication is compiled on the vivado platform using VHDL language, and it can be successfully verified with the EGO1 development board.)