搜索资源列表
ex_dcmotor_timer_128
- AVR example file dc motor timer
avr3
- AVR利用定时器1与比较匹配中断在OC1B引脚接一个二极管，作脉宽调制试验。程序使用内部1M晶振-AVR compare match with the use of Timer 1 interrupt pin in OC1B a diode for pulse-width modulation test. Uses an internal crystal 1M
lesson6_Int_Timer0
- 改程序是基于AVR16F877单片机，其开发环境是AVR studio，主要功能实现对AVR单片机定时器的控制，在实验板上调试成功！-Reform program is based on the AVR16F877 microcontroller, its development environment is AVR studio, main function of the AVR microcontroller timer control, in breadboard debugging su
lesson6_Scan_Timer0
- 改程序是基于AVR16F877单片机，其开发环境是AVR studio，主要功能实现对AVR单片机定时器查询方式的控制，在实验板上调试成功！-Reform program is based on the AVR16F877 microcontroller, its development environment is AVR studio, main function of the AVR microcontroller timer check mode control, in breadboa
servo
- Source code for controlling servo motor using AVR ATmega128 microcontroller. This code using timer interrupt handler. This file is for codevision avr.
chengxu
- AVR单片机的中断和定时器的学习程序，对初学者有一定参考价值-The single chip microcomputer timer interrupt and AVR learning program, have certain reference value for beginners
eggtimer
- Egg timer on tiny AVR
test
- AVR单片机的定时器中断程序，用来控制数码管显示数字，可以在ICC软件中编译通过。现在到AT16单片机中运行-The timer interrupt program of the AVR microcontroller used to control digital display digital, you can compile in the ICC software through. Now run to the AT16 microcontroller
time
- IAR下AVR的定时器使用，演示用来设定定时器-IAR AVR timer, the demo is used to set the timer
10.TC0-Counter
- AVR学习笔记之定时记数器0实验1 TC0-Clock-AVR TIMER
avrlib-by-Procyon
- AVR的库C程序源代码，功能包括 Timer(s)，Uart(s)，A/D Converter，I2C Master/Slave，SPI Interface，Byte Buffering (circular)，Bit Buffering (linear)，Printf and other formatted print functions，VT100 Terminal Output，Command Line Interface，FAT16/32 File System (support is r
AVRtimer0
- 本文讲述AVR定时/计数器0的各种使用，包括各个寄存器的使用方法、电路、波形，并给出了几个不同的程序，有计数实验、定时实验、比较匹配实验、快速PWM实验、相位修正PWM实验。-This article describes the AVR timer/counter of a variety of uses, including the use of various registers, circuit, waveform, and gives a few different programs,
cklcd
- ATmega16 AVR单片机用串行方式控制12864液晶（带字库）内加外部中断0，外部中断1，定时器T0，T1程序-AVR microcontroller ATmega16 with serial mode control 12864 liquid crystal (with word stock) add external interrupt 0, external interrupt 1, T0 timer, T1 program
axv
- avr mega16单片机写的函数发生器，利用定时器器中断发生正弦波、三角波、锯齿波， -avr mega16 microcontroller to write the function generator, timer interrupt occurs sine, triangle, sawtooth,
mega16csb
- 编译环境iccavr 芯片avr16 8M晶振 超声波的可收发距离在3m左右，利用了avr的定时器1和外部中断，1602显示具体距离-The compiler environment iccavr chip avr16 8M crystal can send and receive distance of about 3m using avr timer and external interrupt, 1602 distance
AVR_timer
- 实现AVR定时器功能的配置，实现对AVR的定时器熟练掌握-The AVR timer function configuration, the master of the AVR timer
time
- AVR proteus time 定时器的使用 硬件图-AVR proteus time timer hardware chart
AVRduoji
- avr单片机控制舵机，通过两个定时器来实现，定时器0和定时器2.-Avr single-chip microcomputer control steering gear, through the two timer to realize, the timer 0 and timer 2.
PWM
- Atmega 16单片机，这里利用T/C1定时器中断来产生PWM波形。在ICC AVR编译环境下，利用tool 菜单中的application builder生成一个简单的PWM波程序。这段程序以PA0作为PWM波的输出端口。利用T/C1定时器比较匹配和溢出产生两次中断来改变PA0的输出电平。具体过程为：计数器TCNT1从初始值开始不断计数，当发生比较匹配时，把PA0置为低电平，计数器继续计数，当发生溢出中断时，计数器回到初始设定值，并把PA0置为高电平。从而在PA0端口获得一稳定持续的PWM波
Trffic-Light
- 利用定时器中断编写的控制交通灯，采用的是avr atmega16单片机，Icc编译环境，2401无线传输-Timer interrupt write control traffic lights, avr atmega16 microcontroller, the Icc compiler environment, 2401 wireless transmission