搜索资源列表
自动完成寄存器配置的44b0定时中断和ADC程序
- 自动完成寄存器配置的44b0定时中断和ADC程序-automatically register configuration of the suspension and 44b0 regular procedures ADC
配置端口IO交叉开关译码器
- 利用单片机c8051f020由于端口功能很多，需要对端口进行配置。-C8051f020 SCM function as ports, we need the right port setup.
TMS320F2812中FLASH寄存器的配置问题解答
- TMS320F2812中FLASH寄存器的配置问题解答-TMS320F2812 which registers the configuration Questions
dsp6713定时器程序实例
- 详细的dsp６７１３配置，熟悉定时器的使用，多多交流
ov7725.CMOS图像传感器OV7725的寄存器配置信息
- CMOS图像传感器OV7725的寄存器配置信息,CMOS image sensor OV7725 registers configuration information
VxWorks_PCI_Bridge_Config.rar
- 介绍了PCI桥的配置空间配置头的结构及其配置原理，介绍了配置空间的访问方法；详细阐述了三种桥（PCI-PCI桥、PCI-ISA桥以及PCI Host桥）配置及其层次结构，对应的各个寄存器的含义，结合VxWorks系统，讲述了基于PowerPC架构的PLX6150桥（PCI6150）芯片、W83628AG以及MPC8247 PCI桥的配置和实现方法。 关键词：PCI桥；PLX6150桥芯片；W83628AG；MPC8247；VxWorks,Describes the PCI bridge con
STM8S_register
- STM8的中文版寄存器参考手册。详细介绍了STM8各寄存器该如何配置。-The Chinese version of the register STM8 Reference Manual. Described in detail how to configure the register STM8.
ad5399
- AD5399是一款串行输入、双通道、12位数模转换器，可采用二进制补码数字编码。。 用Verilog实现其配置与功能-AD5399 is a serial input, dual-channel, 12-bit DAC, digital code can be twos complement. . Configuration and use Verilog functions to achieve its
WebTools
- 用于定时执行存储过程的程序，并可以配置多个定时器。-Stored procedure for the regular implementation of the procedures and multiple timers can be configured.
FullbridgeInverter
- 采用极点配置的电压电流双PI闭环PWM逆变器仿真-Pole placement using the voltage and current dual-PI closed-loop simulation of PWM inverter
timer
- 外设timer设计：16bit定时器、ETU计数器、具有3种可配置中断请求输出、内部寄存器的读写编程。-Peripheral timer design: 16bit timer, ETU counter, with 3 configurable interrupt request output, the internal register read and write programming.
实验8 定时器中断实验
- 通过定时器中断配置，每500ms中断一次，然后中断服务函数中控制LED实现LED1状态取反（闪烁）。(Through the timer interrupt configuration, each 500ms interrupt once, and then interrupt the service function to control the LED to achieve the LED1 state, take the inverse (blinking).)
STM32F407的定时器中断例程
- 关于STM32F407的定时器中断配置。。。。。。(Timer interrupt configuration for STM32F407.....................)
KH-LINK
- M430自带定时器实现的代码，可配置各种定时间隔。(M430 comes with the timer to achieve the code, you can configure a variety of timing intervals.)
4-SysTick—系统定时器
- 通过STM32F103 RCC RTC的配置，实现系统定时器功能(The system timer function is realized through the configuration of STM32F103 RCC RTC)
encoder
- stm32编码器模式及中断配置,可以利用stm32读取正交编码器。CNT寄存器没10000代表一圈，每一圈产生一个中断，可以实时读取每一圈CNT值，以及总圈数(Stm32 encoder mode and interrupt configuration, you can use stm32 to read the quadrature encoder. CNT register no 10000 on behalf of a circle, each lap to produce an inte
定时器中断实验
- STM32F103VE 单片机简单的定时器配置(STM32F103VE microcontroller simple timer configuration)
定时器
- 用STM32F103C8T6芯片完成定时器功能。主要是一些配置可以参考，还有注意中断服务程序。(Use STM32 chip to complete timer function)
STM8S103F3P6产生两路互补PWM波配置
- 搞了两天，总算使用STM8S103F3P6最小化系统板的TIM1产生两路互补的PWM波，现拿出来分享一下。工程为IAR环境，寄存器配置。(For two days, we used the STM8S103F3P6 to minimize the TIM1 of the system board to produce two complementary PWM waves, and now to share it. The project is IAR environment, register
STM32GPIO配置
- 本源码为基于STM32配置GPIO的源代码，主要是基于GPIO的基本结构和工作原理、工作模式，实现对其寄存器的配置(This source code is based on STM32 configuration GPIO source code, mainly based on GPIO basic structure and working principle, working mode, implementation of its register configuration.)