搜索资源列表
IDcard
- 这是一个读取ID卡的源代码，仅依靠8052的时钟读取125K频率的ID卡。-This is an ID card read the source code, only 8,052 on the clock read 125K frequency ID cards.
bcan_test
- can总线测试程序，基于80c51，实际调试ok，总线波特率125k
125k_iccard
- 125K IC卡读卡器读头源码，绝对好用！
T2_125Kout
- STC89C51输出125K方波信号，开机初始化就可以输出了，无需程序干预
RFID 读卡
- 125K RFID 读卡程序
125K曼彻斯特编码的只读ID卡读头程序
- 125K曼彻斯特编码的只读ID卡读头程序,Radio Freqency Identification 125K
hs4095.rar
- EM4095 程序 可以参考下 keil 下编译!,EM4095 process can refer to the next under the keil compiler!
RFID-Reader(SchPCB).zip
- RFID 读卡器设计原理图与PCB图，难得的设计资料图,RFID reader design and PCB schematic diagram, the design data for rare
2007112748484065
- 10cm-2(125khz)读卡器原理图，2款125K的ID卡读卡器的设计图-10cm-2 (125khz) reader schematic, 2 125K' s ID card reader design
hs4095
- EM4095开发板配套软件，支持读EM4100、读写EM4469 等125K RFID-EM4095 software development board to support the Reading EM4100, such as 125K RFID reader EM4469
id-read
- 125K ID读卡器原理图，分立元件搭的-125K ID card reader schematic, take the discrete components
2
- 51普通io口调整125K 都射频卡例子-51 ordinary io I adjust the RF card are examples 125K-----
RFIDreaderprogram
- RFID读卡程序。硬件工作原理：基站在上电的情况下通过耦合线圈发射频率为125k的正弦波，ID卡的耦合线圈在125k的正弦波的激励下产生感应电动势，它为整个ID卡提供电源。ID卡通过调制电路根据其卡类的数据使ID卡的耦合线圈也发出正弦波，基站的耦合线圈接收到，根据它与125k波的不同来表示不同的数据。并将其通过DATA端以曼切斯特码的形式输出。-RFID reader program. Hardware it works: At the base station on the case of e
111
- 125k t5557卡 读写-keil C51 T5557 READER
11111
- 125k em卡读卡程序 门禁设计源码 125k em卡读卡程序 门禁设计源码-125k em card reader access control procedures for the design of source
pk-zxr1
- 利用AVR单片机操作U2270B及电控锁-operation U2270B use AVR mcu, RFID 125K
ourdev_183894
- 125K RFID 解碼源程序 , EM4095-125K RFID decoding
firmware_one_for_erfid1
- 125K RFID 读卡程序 avr芯片-125K RFID reader chip program avr
125k-RF-card-em4100-information
- 125k RF card em4100 information
125K-IDreader
- 125K ID读卡器解码。采用STC11F02单片机对125K ID读卡信号采集并且解码验证输出。-125K ID card reader to decode. Using STC11F02 125K ID card reader microcontroller decodes the signal acquisition and verify the output.