搜索资源列表
danxiang
- 单端故障解二次方程法算法，结合PSCAD使用，得到故障测距距离-Single-ended fault solution algorithm quadratic equation method, combined with PSCAD used by fault location distance
faultlocation_fancj
- 基于相量测量的输电线路故障测距新算法 关键词：相量测量；线路参数；故障测距-PMU for Transmission Line Fault Location Algorithm Key words: phase measurement line parameters fault location
faultlocation_lxn1
- 基于分布参数模型的比相式单相故障单端测距算法 关键词：输电线路；单端故障测距；分布参数：比相；ArP 仿真-Distributed parameter model based on single-phase than with single-ended fault location algorithm Key words: transmission line single-ended fault location distribution parameters: ratio of p
zkj
- 距离保护算法仿真主程序 采用故障突变量启动算法和故障突变量选相算法； 根据故障突变量选相结果确定阻抗元件计算或测距元件计算相别- Distance Protection with Fault Simulation main break variable amount of start algorithm and fault phase selection algorithm mutation mutations in the amount of fault phase se
xiaobomojidazhi
- 可以提取信号的突变量，用于电力系统故障测距方面-Mutations in the signal can be extracted amount of respect for the power system fault location
aw2
- 基于改进半软阈值降噪法的输电线路故障测距.-Based on the improved half soft threshold denoising method in the fault location of transmission line.
single_end_fault_location
- 单端频域法故障测距程序，采用零序电流相位修正法，精度较好-The single-ended fault location procedures using frequency domain method with good precision
wave_method_fault_location
- 本程序是利用单端电气量依据行波原理实现故障测距的程序，需要较高的采样率以提高精度。-This procedure uses traveling wave principle of the single-terminal electrical information in accordance with the procedure of fault location, it requires a higher sampling rate in order to improve accuracy.
x_three_ground
- 配网故障测距，用于三相短路情况下的配网故障测距，使用双端信息量，可以较好的测距-Distribution network fault location, for the case of three-phase short-circuit
shuangduandianqiliangguzhangceju
- 基于双端电气量的故障测距，里面的输电线路是分布式输电线路，所以该模型已经考虑到了分布参数对测距的影响，能进行稳定而精确的测距！-Based on samples at both ends of the fault location, inside the transmission line is a distributed transmission line, so that the model has taken into account the effect of the distribut
Untitled6
- 传输线故障测距，方法简单易于理解，可行性高(The transmission line fault location method is simple, easy to understand and feasible)
untitled724
- 传输线故障测距，方法简单易于理解，可行性高希望对读者有帮助(The transmission line fault location method is simple, easy to understand and feasible)
PSCAD中的波形导入到Matlab-PSCAD
- 风能功能实现，包括DFIG以及风电场的各种模型。主要由PSCAD软件搭建的模型。包括线路故障，低电压穿越，以及线路测距的各种模型。(The wind and a variety of functions, including DFIG model of wind farm. Mainly by the PSCAD software to build the model.Including the fault line, low voltage ride through, and a variet