搜索资源列表
小车避障
- 这是一个用汇编写的8051单片机系统的小车避障程序,是用红外发射和接收的方式,并结合了proteus 6.7,相信对初学者有所帮助-This is a compilation was made with the 8051 System of Dolly obstacle avoidance procedures is the use of infrared transmitting and receiving the way, and coupled with a 6.7 lic sure to
HSDL7001
- HSDL7001红外发射和接收器件的测试程序,VB下开发,用于对该器件的批量测试。
infrared
- DS18B20温度采集然后红外发射出去,接收板接收红外并LCD显示接收的数据信息,有完整的发射\\接收程序
红外发射接收芯片HT12A,HT12D,TSOP17378资料
- 红外发射接收芯片HT12A,HT12D,TSOP17378资料--Technical materials for infrared sending/receiving chip HT12A,HT12D,TSOP17378.
hongwai
- 上传一份关于红外通信 常用的红外发射和接收头的引脚判断
红外线发射与接收源程序
- 该程序可用于遥控器制作参考或者其他红外控制的项目,单片机采用的是PIC系列的-the procedure can be used for remote reference to the production or other infrared control of the project, the 8031 PIC is the series of
红外语音控制
- 三路红外线探头控制ISD2560语音播放。主要原理是正常情况下三对红外线接收管接收到各自配套对应的红外发射管的红外线,属于正常检测状态,一旦有一路红外管信号被隔断,侧启动语音芯片程序,播报警示提醒语音或报警。三对红外管可以根据使用需要,设置搭配报警程序。可用于各种排队系统。-three-way infrared probe control ISD2560 voice broadcast. The main principle is that under normal circumstances
52单片机红外发射与接收OK
- 52单片机红外发射与接收OK
ir500
- SNC539 红外发射接受二合一程序,即发射和接收程序为一个程序,可分别接发射和接收。-SNC539 infrared emission to accept two-in-one procedure, namely, transmitting and receiving procedures for a program can then transmit and receive respectively.
Learningremotecontrol
- 单片机设计的遥控电路,遥控码的脉宽数用红外线接收器解码后送单片机读入,发射时由单片机产生40KHZ红外调制信号送红外线发射管发射-Single-chip design of the remote control circuit, remote control code number of the pulse width decoder using infra-red receiver to read single-chip evacuation, launch generated by sing
jj
- 红外遥控器已被广泛使用在各种类型的家电产品上,它的出现给使用家器提供了很多的便利。红外遥控系统一般由红外发射装置和红外接受设备两大部分组成。红外发射装置又可由键盘电路、红外编码芯片、电源和红外发射电路组成。红外接收设备可由红外接收电路、红外解码芯片、电源和应用电路组成。通常为了使信号能更好的被传输发送端将基带二进制信号调制为脉冲串信号,通过红外发射管发射。本设计采用Atmega8作为红外发射编码和接收解码芯片。-Infrared remote control has been widely us
fuzahongwai
- 一个复杂的红外控制小灯程序,将红外发射和接收分开来写的程序,独立成两个模块-Infrared control of a complex process of small lights, to transmit and receive infrared separate written procedures, separate the two modules
hongwaifashejieshou
- 红外发射接收 利用单片机控制红外发射管发射脉冲个数 红外接收根据接收的个数来确定相应的指令-hognwai
mcu
- 基于AT89C52单片机的红外发射与接收系统的研究-AT89C52 microcontroller based infrared emitting and receiving system
Infrared-wrote-since-solution
- 红外发射跟接收,都是用单片机来做的,注释很详细,解压之后就可以直接用的了,硬件没有问题的话挺稳定的-Infrared emission with receiving, are used to do, comments microcontroller is very detailed, decompression can be directly used after, hardware without the word of the problem is stable
红外解码
- 红外解码,对常用红外遥控发射芯片UPD6121G进行解码,根据接收到波形显示其 32位二进制红外编码数据波形,根据波形下方刻度可查阅每一位为0或1(Infrared decoding, commonly used infrared remote control chip UPD6121G chip decoding, according to receive the waveform display 32 bit binary infrared coded data waveform, ac
基于51单片机红外发射与接收C程序
- 基于51单片机红外发射与接收C程序,一个发送端程序,一个接收端程序(C program based on infrared emission and reception of 51 single chip microcomputer)
28. 红外遥控实验
- 红外遥控器发射红外键值的编码信号,通过红外接收头进行解码,并将解码后的数据通过串口打印(Infrared remote controller emits a coded signal of infrared key value, decodes it through an infrared receiver, and prints the decoded data through a serial port.)
15 红外遥控收发仿真
- 用proteus仿真红外接收,发射,已成功。(Proteus simulation of infrared receiving, launching, has been successful.)
单片机控制红外发射接受
- 51单片机c源代码+红外发射接收串口通信(c source code;micro controller; infrared; embedded system;)