搜索资源列表
nrf24l01
- 基于mega8的NRF24L01通讯程序，可实现4个按键-Based mega8 of NRF24L01 communications procedures, can be four key
nRF24L01
- 基于nRf24L01，S52，保证通过，接收端-Based on nRf24L01, to ensure passage of the receiving end
STC89C51-24L01
- NLF2401程序，单片机无线收发程序，很好用，均已调试过，初学者、高手均适合使用。-NLF2401 procedures, SCM wireless transceiver procedures, very good use, has been debugging, for beginners to master, all suitable for use.
24L01
- 2.4G无线模块半双工程序，绿色版本测试通过，超过15M距离-2.4G wireless module half the program, the green version of the test, more than 15M distance
24l01
- nRF24l01无线模块 发送端程序for AT89S52单片机-nRF24l01 wireless module sending application for AT89S52 microcontroller
nrf
- nrf2401在linux下的驱动程序。含有调用的程序-nRF2401 in under linux drivers. Containing the procedure call
nrf
- nrf2401无线收发C语言程序，调试通过，用的是lpc2103的MCU-nrf2401 wireless transceiver C language programs, debugging through the use of the MCU is lpc2103
lingyang_nRF24L01_TX
- 凌阳-24l01 驱动程序 无线2.4g 2m bit-2.4g 2m bit
BK2411
- BK2411资料难找，BK2411使用起来跟24L01基本一样，硬件上基本兼容，软件上只是开始要对BK2存储器进行初始化，花掉很长一段代码。初始化完成后，操作就跟24L01基本一样了-BK2411 information hard to find, BK2411 to use essentially the same with the 24L01, the hardware basically compatible, software is only the beginning of the B
2401V1.0
- 2401传输模块使用手册，超好用 2401传输模块使用手册，超好用-2401 manual transmission modules, Chao Haoyong manual transmission modules, Chao Haoyong manual transmission modules, Chao Haoyong
receice
- 51单片机控制24L01无线模块收发程序 8路按键控制8路LED显示-51 SCM control 24L01 wireless transceiver module 8-way key control procedures for 8-way LED Display
2.4G
- 基于24L01的无线发射程序，使用方便。应用广泛-24L01-based wireless launch program, easy to use. Widely
SPI_test_reg
- 用于检测2052与24l01之间SPI链接状况，读寄存器-test the connection between 2052 and 24l01
NRF24l01_wireless_for_232
- 使用8051单晶片控制24l01,完成一个无线的rs232双向传送的介面-for wireless rs232 interface design by 8051 and 24l01
nrf24l01
- MSP430单片机的nrf24L01驱动程序，已经测试成功，实现无线数据收发-Nrf24L01 MSP430 MCU driver has been tested successfully, wireless data transceiver
2401test
- 51模拟SPI时序配置无线模块24l01 进行收发-51 SPI timing simulation to configure the wireless transceiver module 24l01
Sonix_2.4G_wireless_audio_module_spec_0v3
- 2.4G射频语音通信芯片设计方案,采用Sonix芯片，集成AD,滤波等-2.4G RF voice communication chip design, using Sonix chip, integrated AD, filtering
NRF_24l01_success_02
- 无线2.4G通信send测试程序，一个发射，一个接收，只需要改个端口，NRF24L01的发射模块，接收端将数据发送到串口调试助手-2.4G wireless communication send test program, a transmitter, a receiver, just change the ports, NRF24L01 the transmitter module, the receiver sends data to the serial port debugging as
SHT11_24L01
- 利用温湿度传感器SHT11采集温湿度 并通过24L01发送出去 另一端接受并在诺基亚5110液晶上显示。程序比较简单，因为时间要求十分紧迫，所以程序写法不太合规范，请谅解哈。-SHT11 collected using temperature and humidity sensor temperature and humidity, and sent through the 24L01 and the other end to accept the Nokia 5110 is displayed
FIRE_ROBOOT
- 无线模块24L01的驱动和测试程序，经过验证，可以正常使用。-Wireless module 24L01 drivers and test program, after verification, can be used normally.