搜索资源列表
check-FM-radio
- FM 接收机测试方法: 为了接收性能的比较及评价，作为规定测试方法。另外，ＦＭ ＭＰＸ 立体声接收机也适用于此测试方法 -FM receiver testing method : To compare the performance of the receiving and evaluation, as a required test. In addition, the FM stereo receiver MPX also apply to this test method
RDA5802_03_datasheet_v2_0.rar
- The RDA5802/03 is a single-chip broadcast FM stereo radio tuner with fully integrated synthesizer, IF selectivity and MPX decoder. ,The RDA5802/03 is a single-chip broadcast FM stereo radio tuner with fully integrated synthesizer, IF selectivity and
5800C
- 5800C Fm芯片资料和驱动代码 技术特点： *国内首颗采用CMOS工艺的调频收音机芯片； *驱动能力强，可直接驱动耳机及放大器； *功耗低，比国外先进方案还低1mA； *频率覆盖从76M-108M的各国调频波段； *高度集成度，所需外围器件数为零； *强大的LOW-IF数字音频结构； *强大的数字信号处理技术（DSP）,实现自动频率控制和自动增益控制； *数字自适应噪声抑制 接受灵敏度高、音质出色、立体声效果优异； *支持重低音，可调式电台搜寻、柔
Tuner
- 这是数控调频发射器的汇编程序，可在80.0到109.9MHz范围内任意设置发射频率，可预置11个频道，具有单声道/立体声控制-This is the FM transmitter NC compilation process can be within the scope of 80.0 to 109.9MHz frequency arbitrarily set to launch, can preset 11 channels, with Mono/Stereo control ......
bh1418fv
- AT89C2051控制BH1418FV调频立体声发射模块程序-AT89C2051 control BH1418FV FM stereo transmitter module procedures
dangonghujiaojieshouji
- 接收部分以超大规模AM/FM立体声收音集成芯片CXA1238S为主体，灵敏度、镜像抑制、信噪比等各项性能指标均达到设计要求；音频功率放大器采用集成芯片LM386，电压放大倍数最大为200。-Receive part of ultra-large-scale AM/FM stereo radio IC CXA1238S as the main body, sensitivity, image rejection, signal to noise ratio and other performanc
72130
- 汽车音响FM收音模块。车载收音机LC72130驱动，-Car Stereo FM radio module. Car Radio LC72130-driven,
tea5767source
- Low-power FM stereo radio for handheld applications
SP3767HN
- SP3767HN Fm stereo radio
simplex_wireless_calling_system
- 单工无线呼叫系统分发射和接收两大部分。发射部分采用锁相环式频率合成器技术， MC145152和MC12022芯片组成锁相环，将载波频率精确锁定在35MHz，输出载波的稳定度达到4×10-5，准确度达到3×10-5，由变容二极管V149和集成压控振荡器芯片MC1648实现对载波的调频调制；末级功放选用三极管2SC1970，使其工作在丙类放大状态，提高了放大器的效率，输出功率达到设计要求。接收部分以超大规模AM/FM立体声收音集成芯片CXA1238S为主体，灵敏度、镜像抑制、信噪比等各项性能指标均达
Kstereo
- Generator for FM stereo encoder
QN8000
- 调频立体声发射器QN8000的底层接口程序。-FM stereo transmitter QN8000 the bottom interface program.
ch5example6
- 调频立体声接收机模型 对相应的立体声解码过程进行建模和仿真。设左右声道的信号分别为1000Hz和2000Hz的单频测试信号。 -FM stereo receiver model for the corresponding stereo decoding process modeling and simulation. Set left and right channel signals were 1000Hz and 2000Hz single frequency test signal.
CXA1019
- 本调频收音机主要由FM/AM收音机芯片CXA1019、PLL且频率合成器BU2614和单片机AT98C51组成。收音机以单片机AT98C51为控制核心, 实现全频搜索、指定频率范围搜索和手动搜索电台 本收音机还使用了数字电位器(X9511)控制音量。采用液晶显示器显示载频和时钟等信息, 大幅度降低了系统的功耗。整机实现3V 电源工作, 采用E2PROM(AT24C04)存储电台, 还增加了立体声解码功能。-Mainly by the FM radio FM/AM radio IC CXA1019
principle-of-communication
- 模拟传输技术——FM立体声合成信号实验：用于处理一段音乐文件，通过采样、双边带调制解调得到我们能播放的音乐-Analog transmission technology, FM stereo synthesizer signal experiment: used to process a music files, by sampling, bilateral take demodulation get we can play music
RDA5807M
- RDA5807M参考代码 The RDA5807M series is the newest generation single-chip broadcast FM stereo radio tuner with fully integrated synthesizer, IF selectivity, RDS/RBDS and MPX decoder. The tuner uses the CMOS process, support multi-interface and
TEA5767HN
- 低功耗便携式立体声调频收音机芯片 集成于单芯片-Low-power FM stereo radio for handheld applications
pll
- Phase Locked Loops (PLL) Introduction to PLL The concept of Phase Locked Loops (PLL) first emerged in the early 1930’s.But the technology was not developed as it now, the cost factor for developing this technology was very high. Since the adva
FM-stereo-signal-simulation
- 是FM调频立体声的调制解调的matlab仿真代码，实现了对双声道语音的调制和解调，非simulink方式，完完全全的matlab代码-This is for FM stereo radio signal modulation and de-modulation code. it is not for matlab simulink, it is completely matlab code, you can follow it and for understanding FM stereo si
easydabv2_sfn-05.08.2017.tar
- FM Stereo modulator FPGA