当前位置：
首页 资源下载
搜索资源 - topology control simulation
搜索资源列表
-
0下载：
本文介绍了CBTC和CLTC这两种拓扑控制算法，并使用OPNET仿真了他们的实现和性能分析。,This paper introduces the CBTC and CLTC these two topology control algorithm, and using OPNET simulation of their achievement and performance analysis.
-
-
0下载：
A Cooperative Approach for Topology Control in Wireless Sensor Networks Experimental and Simulation Analysis
-
-
0下载：
利用NS仿真工具动态调整节点发射功率＆节点定位拓扑控制-NS simulation tool used dynamic adjustment of transmitting power, topology control & Localization
-
-
0下载：
无线传感器网络在煤矿中的仿真设计 提供了一种监控系统模型以及传感器网络的结构，并且对传感器网络的拓扑控制技术进行了研究及仿真。-Wireless sensor network simulation in the coal mine design a monitoring system model and the structure of sensor networks and sensor network topology control technology research and simu
-
-
0下载：
单相准Z 源逆变器及其SVPWM 控制策略研究
冷志伟， 齐琛， 陈希有
（大连理工大学，辽宁大连116024）
摘要：主要研究了一种新型拓扑结构的Z 源逆变器，即单相准Z 源逆变器。分析了其等效电路及其运行状态，并将空
间矢量脉宽调制（SVPWM）技术应用到单相准Z 源逆变器中，着重分析了调制的基本原理并给出了单相准Z 源逆变
器基于SVPWM 的控制策略。仿真和实验结果表明，相对常规Z 源逆变器，准Z 源逆变器能够有效抑制启动冲击电
流，显著降低Z 源网络中电容器件的
-
-
0下载：
simulation code for a topology control algorithm span
-
-
0下载：
In today’s most of the Adhoc networks needs the reliable connection to transfer the data. Most number of
data packets loss is experienced in the Adhoc networks due to Transfer control protocol(TCP)’s high channel
error rate and link failur
-
-
0下载：
Buck变换器是最常用的变换器，工程上常用的拓扑如正激、半桥、全桥、推挽等也属于Buck族，其中Buck变换器补偿网络设计，是开关电源的重要研究课题，本文将针对基于PI控制方式的4A开关电源进行设计和Multisim的仿真研究。-Buck converter is the most commonly used converter on the topology of the project, such as forward, half bridge, full bridge, push-pull
-
-
0下载：
This paper proposes an open switch faults detection and localization algorithm for shunt three
phase active filter topology. It mainly details converter configuration and examines a simple and
reliable optimised fault diagnosis method. The con
-
-
0下载：
Simulation of five level FC-Hbridge multilevel inverter topology is uploaded with control and power circuit.
-
-
0下载：
This paper describes different power quality
problems in distribution systems and their solutions with
power electronics based equipment. Shunt, hybrid and
series active power filters are described showing their
compensation characteristics a
-
-
0下载：
This paper proposes an improved Z-source inverter topology. Compared to the traditional Z-source inverter, it can reduce the Z-source capacitor voltage stress significantly to perform the same voltage boost, and has inherent limitation to inrush curr
-
-
3下载：
采用载波移相和PI控制器的（电流前馈解耦）STATCOM仿真，电路拓扑为H桥级联，实现了直流侧电压的平衡控制-Using STATCOM simulation of carrier phase shift and the PI controller, the circuit topology for the H bridge cascade, the realization of DC side voltage balance control
-
-
0下载：
This the PSCAD project file for the modeling and control of high-voltage direct current (HVDC) transmission line. Control algorithms are simulated in the file. Power electronic devices are modeled in detail. This file is very useful for beginner to l
-
-
0下载：
This report is about the development of efficient electric power conversion solutions for
photovoltaic panels. Different solutions are presented and an overall perspective is shown.
From the characteristics of the photovoltaic panels to the power
-
-
0下载：
This paper presents a dual voltage source inverter
(DVSI) scheme to enhance the power quality and reliability of
the microgrid system. The proposed scheme is comprised of two
inverters, which enables the microgrid to exchange power generated
-
-
1下载：
针对短信网络内病毒传播行为的多样性特点,在研究短信网络生长过程及其拓扑结构的基础上,采用SEIR模型构造元胞自动机模拟方法,对病毒在短信网络内的传播过程进行了模拟仿真,并在此基础上研究了用户反应时间、预免疫与病毒变异对短信病毒传播的影响.实验结果表明,该自动机模型能较好地模拟短信网络中病毒的传播过程.同时针对病毒的传播特点提出了有效的防治策略。-According to the characteristics of the diversity of the virus spreading beh
-
-
0下载：
传感器节点在链状拓扑结构中的传输仿真，可控制跳距，跳数，节点间距离(The transmission simulation of sensor nodes in chain topology can control hop distance, hop count and distance between nodes)
-
-
0下载：
单相逆变并网电路的主电路与控制电路的 simulink 拓扑结构图，
主电路由直流源、 mosfet 全桥、 LC 无源滤波器、 负载 R1、 R2 组成， 其中 R1 为
恒定负载， R2 为仿真负载突变并入的。
控制电路为 SPWM 闭环调制， 通过检测输出端的电压有效值通过 PI 控制器反
馈回控制端使输出电压尽可能为一个优质的正弦波且有效值在 220V 左右， 频率
为 50Hz， 根据相关准则输出电压波形 THD 应在 5%以内。(The Simulink topology
-
-
0下载：
完成了对光伏发电并网控制的设计及仿真。系统采用了两级式拓扑结构：前级用直流变换器进行最大功率跟踪及直流母线电压调整；后级用逆变器将直流电能逆变送入电网。(Completed the design and simulation of photovoltaic grid-connected control. The system adopts a two-stage topology: the front stage uses a DC converter for maximum power tra
-
