搜索资源列表
source
- 9轴气压指南针,调试程序，加速度，陀螺仪，气压传感器，电子罗盘-9-axis compass, barometric pressure, debugger, accelerometer, gyroscope, pressure sensor, electronic compass
BMP085
- 基于单片机STC89C51的气压传感器BMP085的测试程序。-Microcontroller-based pressure sensor BMP085 STC89C51 testing procedures.
wet-bulb-temperature-calculation
- 利用平均风速、相对湿度、平均气压等要素计算湿球温度-wet bulb temperature calculation
Micaps-GRADS
- 支持气压 温度、温度露点差、U、V分量 Se 涡度 散度 垂直速度 比湿 水汽通量 相对湿度 总温度 K指数 KY指数 Si指数的转换，程序简单，只需要输入文件名就可直接使用-Support pressure temperature, dew point temperature difference, U, V component Se vertical vorticity divergence faster than wet vapor flux relative humidity KY to
Turbocharger-parameter-measurement
- 汽车涡轮增压器参数测量标定。使用DZ60单片机，实时测量增压器前后温度气压等参数。-Automotive turbocharger parameter measurement calibration. Use DZ60 microcontroller, real-time measurements before and after the temperature turbocharger pressure and other parameters.
HMC085_OK
- 单片机STC90C516RD，读取BMP085程序，读出气压和温度，并通过串口发送显示-SCM STC90C516RD, read BMP085 procedures, pressure and temperature read out and displayed through the serial port
COM-DISP5.0
- 在地铁轻轨运行的车载监控显示程序，工控机串口接受PIC单片机发送来的串口数据，在界面显示各个轮胎的温度气压电压数据，并适时做出判断，做出报警指示。工程调试通过运行源码！-In the metro and light rail vehicle monitoring display program running, IPC PIC microcontroller serial port accepts serial data sent by the interface displays the te
GPS2-12-18
- 在WINCE6.0环境调试开发的ARM9-2440硬件串口通信程序，嵌入式ARM接受2串口，发送1串口数据，适时监控下位机发送的轮胎电压温度气压数据，经适时处理分析在7寸界面显示个车厢轮胎的状态信息，源码调试通过并在轻轨车上运行-WINCE6.0 debugging environment in the development of ARM9-2440 hardware serial communication program, embedded ARM accepts two serial p
CC2530_BMP085
- IAR8.10下CC2530单片机上调试的气压传感器：BMP085驱动。-Driver for Sensor of Air Pressure Used on MCU CC2530,Developed under IAR8.10.
air-pressure
- 用Atmega128与HP03S编写的气压检测程序-Prepared with Atmega128 with HP03S pressure testing procedures
stc12C5Abmp085-
- STC 连接bmp 085 做的气压检测。。。测试程序。。液晶显示-STC 连接bmp 085 做的气压检测。。。测试程序。。液晶显示。。。
BMP085
- 使用PIC18F4550单片机，读取气压传感器BMP450的值，换算成高度后，通过USART发送。-The MCU PIC18F4550 send data from BMP450 sensors through USART to PC
qyj
- 气压计proteus仿真，液晶显示电路显示出实际气压值，当气压值大于100KPa时，蜂鸣器发出报警提示音。-Barometer proteus simulation, liquid crystal display circuit shows the actual pressure value, when the pressure is greater than 100KPa, buzzer alarm beeps.
AWS
- 本程序用于自动气象站采集器修改气压模块参数-This procedure is used to modify the pressure AWS acquisition module parameters
Yan-Gong-Min-_-PhD-thesis
- 严恭敏_博士学位论文 论文中采用激光陀螺捷联惯导系统为主导航系统，通过与里程计和气压高度计组合，构成车载自主定位定向系统，并借助路标点进行误差补偿。该定位定向系统不依靠 GPS，中途无须停车作零速修正，是一种全自主的导航系统，具有定位定向精度高、机动性好、可靠性高和寿命长等优点。 -In this thesis, laser gyro strapdown inertial navigation system (SINS) is selected as core navigation s
dcfchxu
- 监控气井气压的单片机电路程序，采用AD0804采集，将数据发送上位机串口。MSC51系列单片机，MAX485通讯。-Gas pressure monitoring microcontroller circuit program, using AD0804 acquisition, PC serial port to send data. MSC51 series microcontroller, MAX485 communications.
bmp085
- 在linux 2.6下 读写BMP085 气压温度传感器I2C驱动程序-In literacy BMP085 pressure under linux 2.6 I2C temperature sensor driver
Extraction-pressure
- 在气象应用中从ncep资料中提取气压、水汽压-Extraction pressure vapor from the data
BMP085
- 数字气压传感器BMP085应用笔记.pdf-BMP085 digital pressure sensor application notes. Pdf
YLG
- 采用合泰芯片做的一款电压力锅源程序。内部增加了压力开关不气压的处理方式。-Adoption of Thailand chips to do a pressure cookers source. Internal pressure increases the pressure switch is not handled.