搜索资源列表
wps
- 这是电法勘探中常用的电偶源TEM视电阻率计算方法，非常适用-Galvanic source TEM apparent resistivity calculation method
STC_WK
- STC12C5A60S2单片机PCA模块下PWM控制发热电阻-PWM the microcontroller STC12C5A60S2 PCA module control the heating resistor
ev1527
- 基于一款EV1527的解码程序,配合330K震荡电阻使用-Based on the a EV1527 decoding program, with the use of 330K shock resistance
485test
- DM430-L型开发板RS485通信实验，通过开发板与电脑进行数据通信，485接在UART1上 电脑端必备RS232转RS485模块，否则无法进行直接的连接RS485之间通过双绞线连接，如果距离近，可以不使用120欧电阻匹配电脑端通过串口调试助手操作，先将数据由电脑发往开发板开发板板会将收到的数据再发送到串口调试助手，接收采用中断模块，发送用查询板载的BSL模块可以通过跳线帽设置为USB转串口模式，笔记本电脑没有串口可以直接代替开发板的BSL区的RXD和TXD0连接，TXD和RXD0连接即可
relay_tes
- 继电器参数测试,测试电阻及吸合,开启电流-Relay Parameter Test, test resistor, and suction an aggregate, open the current
SeHuanDianzu
- 这是一个不错的电阻计算和显示色环的软件，很不错，仿真界面好，强烈推荐。-This is a good resistance software calculates and displays the color ring, very good, good simulation interface, it is strongly recommended.
VC_SelectR
- SelectR是一款根据所需的阻值，通过串联/并联方式从现有数据库中选择合适的两个阻值，也可以选择固定倍数的两个电阻。-Select a proper resistance
jueyuanjiance
- 基于单片机的绝缘电阻检测仪的设计，单片机开发-failed to translate
open_leftToRightLeds
- 解决在protues仿真流水灯时出现不亮的问题的方法, 就是不要直接连接二极管和电阻, 中间需要加些导线.-Solve the protues simulation to the problem of water occurs when light is not bright, is not directly connected to the diode and resistor, need to add some wires in the middle.
lcd
- lcd.c与adc.c整合以后的源程序，能够显示可调电阻改变的曲线。-the integration of lcd.c adc.c after the source, it will show the adjustable resistance change curve.
Using-Guide-of-Operational-Amplifier
- 集成运放的使用指南，详细地介绍了集成运放的选择以及运放外围电路包括比如旁路电容以及电阻的选择方法。适合设计电路的朋友或者作为教学课件。-Integrated operational amplifier user guide, a detailed descr iption of the integrated operational amplifier selection and op amp peripheral circuits including, for example, the bypa
dianzuceliang
- 基于c51单片机的直流电源的电阻测量，通入直流电源，ad转换器采集信号，经AT89C51处理显示-Resistance measurement of dc power supply based on c51
lcd
- 用到段码液晶屏，一般是用专用驱动芯片如：HT1621等，考虑到，成本、功耗，决定用单片机直接驱动。液晶屏手册建议用1/3偏压，求简单用1/2偏压，实际搭了个实验板试了一下，效果还是不错的。实际可将分压电阻R2-29加大到1M，和用CPU的一个脚来驱动（可关断），进一步减小功耗，现贴出原理图、程序、照片，供有用者参考。 -Used Segment LCD, special driver chip, such as: HT1621, taking into account cost, power
DCmotor
- 他励直流电机直接启动，串电阻启动和降压启动模型。内附三种启动方式的模型图和各类参数变化-Excited DC motor direct start, the string resistance start-up and step-down start model. Included three starts the model diagram and changes in various parameters
LCD1602s
- 刚写好一个LCD1602的四线驱动 硬件连接部分 LCD 引脚与MCU引脚连接定义: D4----RB0 D5----RB1 D6----RB2 D7----RB3 RE----RC13 RW----RC14 E -----RD0 各连接之间最好加上上拉电阻-Had just written a LCD1602 four lines drive the hardware part of the LCD pin connection wit
LCD
- mini2440裸机的十寸LCD，可显示欢迎界面和x、y轴，并能随可调电阻的变化以曲线的形式实时显示在LCD上。-to display the welcome screen and x, y-axis, and the change in resistance with adjustable curve real-time display on the LCD the mini2440 bare metal of the ten-inch LCD.
5.151
- 测电阻，电感，电容，自动切换量程，89c52rc单片机-Measuring resistance, inductance, capacitance, autoranging, 89c52rc microcontroller
Second-floor--
- 电法勘探实验模拟，用于二层电测深电阻率正演模拟-Experimental simulation of electrical prospecting for Layer 2 electrical sounding resistivity forward modeling
1111
- 关于异步电动机定子串电阻启动仿真的课程设计，有详细的参数设置，结果分析-Asynchronous motor stator string resistance to start the simulation curriculum design, detailed parameter settings, the results of
an_r01an0821ej0100_rx62t_ad
- 使用12位AD端口采样的单电阻侦测方法；基于瑞萨RX系列微控制器-12-Bit AD Converter in One Shunt Current Detection Method