利用labview编程：

6. 利用簇模拟汽车控制，如右图所示，控制面板可以对显示面板中的参量进行控制。油门控制转速，转速＝油门*100，档位控制时速,时速＝档位*40，油量随VI运行时间减少。



注意：档位为整数，油量减少速度与档位有关。

7.1 利用随机数发生器仿真一个0到5V的采样信号，每200ms采一个点，共采集50个点，采集完后一次性显示在Waveform Graph上。

7.2 在上题的基础上再增加1路电压信号采集，此路电压信号的范围为5到10V，采样间隔是50ms，共采100个点。采样完成后，将两路采样信号显示在同一个Waveform Graph中。-Labview programming: the use of cluster simulation of vehicle control, shown at right, the control panel can control on the display panel parameters. Throttle control speed, speed = throttle* 100 stalls to control speed, speed = stall* 40, the decrease in oil with a VI running time. Note: The related stalls for integer, oil, reduce speed and stall. 7.1 simulation using a random number generator to a 0 to 5V and the sampling signal every 200ms to adopt a point, collecting a total of 50 points, collecting after the disposable shown in Waveform Graph. 7.2 in the previous question on the basis of an increase of one-way voltage signal acquisition range of the signal in this way voltage of 5 to 10V, the sampling interval is 50ms, of mining 100 points. Sampling is completed, the two sampling signal is displayed in a Waveform Graph.