搜索资源列表
BH1415F_C_Program.rar
- BH1415F调频台控制C程序 使用AT89C52单片机，12MHZ晶振，用共阳四位LED数码管,FM BH1415F control C program uses AT89C52 single-chip, 12MHZ crystal, with a total of four positive LED digital tube
ssss.rar
- 采用8位LED动态扫描时钟演示程序，使用12MHZ晶振，P0口输出段码，P2口作列扫描，用共阳LED数码管。,Using 8-bit dynamic scanning LED clock demonstration, the use of 12MHZ crystal, P0 port output above code, P2 scan I made out with a total of LED digital tube Yang.
bh1415.rar
- BH1415F调频台控制C程序）,使用AT89C52单片机，12MHZ晶振，用共阳四位LED数码管,C FM BH1415F control procedures), the use of AT89C52 single-chip, 12MHZ crystal, with a total of four positive LED digital tube
interrupt
- 用Keil开发的基于C51的中断学习程序，LED显示。按键接在P3.2口，按一次按键，数码管显示加一，在0~9之间循环。注意数码管共阴还是共阳，附上程序对应单片机原理图。本人亲写-Keil development with the interruption of C51-based learning process, LED display. P3.2 access keys in the mouth, according to a button, digital display plus on
Voltage_C_Program
- 八路电压表C程序 使用AT89C52单片机，12MHZ晶振，P0口读入AD值，P2口作AD控制，用共阳LED数码管 P1口输出段码，P3口扫描，最高位指示通道（0-7）。-Eight-way voltage meter C program using AT89C52 single-chip, 12MHZ crystal, P0 I read into the AD value, P2 I make AD control, with a total of P1 Yang LED digit
8bit_LED_show_C_Program
- 采用8位LED动态扫描时钟演示程序 使用12MHZ晶振，P0口输出段码，P2口作列扫描，用共阳LED数码管-Using 8-bit LED Dynamic scan demo program using the 12Mhz clock crystal, P0 port output above code, P2 I make out scanning, with a total of Yang LED digital tube
DS18B20_Thermometer_Program
- DS18B20温度计C程序 使用AT89C2051单片机，12MHZ晶振，用共阳LED数码管-DS18B20 thermometer C program uses AT89C2051 Singlechip, 12MHZ crystal, with a total of Yang LED digital tube
DS18B20
- DS18B20温度计C程序 使用AT89C2051单片机，12MHZ晶振，用共阳LED数码管 P1口输出段码，P3口扫描-DS18B20 thermometer C program uses AT89C2051 Singlechip, 12MHZ crystal, with a total of P1 Yang LED digital tube output above code, P3 port scanning
BH1415F
- BH1415F调频台控制C程序 使用AT89C52单片机，12MHZ晶振，用共阳四位LED数码管 P0口输出段码，P2口扫描-FM BH1415F control C program uses AT89C52 single-chip, 12MHZ crystal, with a total of four LED digital tube Yang P0 port output above code, P2 I scan
xf5
- 4寸大数码管显示,采用共阳级,74595串联移码方式驱动2003达林顿芯片,用89c51的P1.0,P1.1,P1.2连接-4-inch digital display, using a total of Yang-class, 74,595 tandem frameshift driven 2003 Darlington chip 89C51 with the P1.0, P1.1, P1.2 to connect
ds18b20temperature
- 控制器实用单片机AT89C2051,温度传感器实用DS18B20,用4位共阳LED数码管以动态扫描法实现温度显示。-Practical single-chip controller AT89C2051, temperature sensor utility DS18B20, with a total of four digital tube LED-yang dynamic scanning method to achieve temperature display.
74HC164
- 74HC164驱动单个数码管（共阳）程序 74HC164 drive a single digital tube (a total of Shenyang) procedures -74HC164 drive a single digital tube (a total of Shenyang) procedures
Counter
- 计数器程式 控制器为AT89c52单片机,设定按钮,加按钮,减按钮：采用共阳七段数码管显示器。*/-Counter AT89c52 program for single-chip controller, set the button, add button, minus button: Yang used a total of Seven-Segment LED display.* /
fff
- BH1415F调频台控制C程序。使用AT89C52单片机，12MHZ晶振，用共阳四位LED数码管。频率数据转换为显示用BCD码函数。-C FM BH1415F control procedures. AT89C52 single-chip microcomputer use, 12MHZ crystal, with a total of four LED digital tube Yang. Frequency data into a display function using BCD co
8vod
- 使用AT89C52单片机，12MHZ晶振，P0口读入AD值，P2口作AD控制，用共阳LED数码管， P1口输出段码，P3口扫描，最高位指示通道（0-7）。-AT89C52 single-chip microcomputer use, 12MHZ crystal, P0 I read into the AD value, P2 for the AD population control, with a total of Yang LED digital tube, P1 port output
Thermometer
- 语音温度计 使用AT89C2051单片机，12MHz晶体，用共阳LED数码管-Thermometer using AT89C2051 single-chip voice, 12MHz crystal, with a total of Yang LED digital tube
shumazhongxianshi
- 数码时钟显示，用8位LED软件译码动态显示，P0为字段码,P2为位选码，数码管共阳， key0为位选键；key1为加“1键；key2为减“1”键。-Digital clock display with 8 LED dynamic display software decoding, P0 code for the field, P2 election code for the digital, digital tube were positive, key0 bond election fo
C
- 8AT89C52,ADC0809 8路数字电压表测量由A/D转换、数据处理及显示控制等组成，测量0～5V范围内的8路输入电压值，由4位共阳LED数码管轮流显示，最大分辨率0.01V，误差±0.02V。-8AT89C52, ADC0809 8 way digital voltage meter measured by A/D conversion, data processing and display control of the measurement range of 0 ~ 5V inpu
Experimentalproceduresstopwatch
- 使用AT89S51单片机，12MHZ晶振，P0口输出段码，P2口作位扫描，用四位共阳LED数码管-Experimental procedures stopwatch
18b20c
- 18b20 晶振12m，P0口为数据口，P2.6和P2.7为扫描端口，共阳LED数码管，P2.2为数据输入口 //如果晶振为24M，把所有延时都乘以2倍 -lue