搜索资源列表
CITS25
- PCB电路设计 RF天线设计 RF阻抗设计及计算软件(PCB circuit design, RF antenna design, RF impedance design and calculation software)
圆阵天线阵的方位角估计music源程序
- 本文件是介绍利用圆阵测向天线基于MUSIC算法的测向技术,可以实现DOA估计。和仰角的估计(This document describes the direction finding technology based on the MUSIC algorithm using the URA direction finding antenna, DOA and elevation estimation can be achieved)
HFSS天线设计_李明洋
- HFSS现代天线设计用HFss设计_李明洋(HFSS antenna design _ Li Mingyang)
天线参考测试项目
- Bluetooth PCB antenna test, impedance test,
余割GA算法
- 利用遗传算法实现对天线方向图的余割综合,得到需要的激励幅相(The realization of programming genetic algorithm for antenna direction chart.)
line
- 线阵天线方向图的画法 可改参量 实现不同参量下的方向图(The Drawing of Line Antenna Pattern)
智能天线(MATLAB版)[何业军][程序源代码]
- 智能天线(MATLAB版)【何业军】一书上部分例子习题的程序(Smart antenna routines)
huan_4m-0.1seawater
- 基于FEKO仿真鞭天线的方向图,可用度天线的方向图等电气参数分析(Simulation of the pattern of two whip antennas)
衍射类型
- 关于相控阵雷达天线的衍射类型,主要是针对孔径方式的不同对光束的影响(Diffraction types of phased array radar antenna)
matlab程序
- 通过遗传算法实现宽带天线的匹配网络优化,提高整个频带内的传输效率、(The genetic algorithm is used to optimize the matching network of broadband antenna and improve the transmission efficiency in the whole frequency band,)
horn_antenna
- 对合成天线进行matlab 仿真,有很强的指导意义(simulation of horn-antenna)
Sparameter
- 用于画从CST里面导出的天线的S参数图,先从CST里面导出S1P文件,再用matlab作图(Used to draw the S-parameter of the antenna derived from the CST)
天线分析仪
- 实现多通道ADC采集,通过图形界面显示,通过操作DDS信号发生器实现扫频,将天线阻抗信息现实吧到屏幕(Multi-channel ADC acquisition, through the graphical interface display, through the operation of DDS signal generator to achieve frequency sweep, the antenna impedance information to the screen reali
矩量法分析八木天线
- 基于矩量法(MoM)的天线分析,以八木天线为例,分析了八木天线的天线电参数特性。(Based on the method of moment (MoM) of the antenna analysis to Yagi antenna as an example, analyzes the characteristics of Yagi antenna parameters.)
MIMO_channel_cap_ant_sel_optimal
- MIMO系统中采用最优天线选择方案的MIMO信道容量(MIMO channel capacity using optimal antenna selection scheme in MIMO system)
dipoantenna
- 本程序通过matlab动态绘制双偶极子天线的极坐标方向图,含注释(This file dynamically shows the pole radition pattern using matlab.)
micro
- 最基础的微带天线,用的是HFSS软件,方便大家学习(The most basic microstrip antenna is convenient for you to learn)
gestrue_3D_modelling_research-master
- 用于UWB芯片的天线校准,使用DW1000的校准指导做出的代码(It is for the calibration of the antenna delay, fit for DW1000 serials)
gongxing
- 利用HFSS完成共形天线,分析天线工作性能(Antenna modeling and simulation)
Monopole
- 应用HFSS仿真平台,构建双频带单极子天线模型,进行仿真(Antenna modeling and simulation)