CDN加速镜像 | 设为首页 | 加入收藏夹
当前位置: 首页 资源下载 搜索资源 - 电源控制

搜索资源列表

  1. SVPWM

    2下载:
  2. 变频驱动主要使用的驱动波形主要有SPWM和SVPWM两种。SPWM原理简单、实现容易,是现在使用最广的一种变频驱动波形。但其有一个致命的弱点是其电源利用率不高(只有86%)、谐波成分大。因此,在新近开发的产品中其应用逐渐被性能优异的SVPWM所取代。SVPWM是一种电压利用率、低谐波成分的变频驱动波形,还有开关次数少、功率管功耗小等特点。同时,SVPWM还能很好的结合矢量控制算法、以最大限度的发挥设备的性能。因此被越来越多的变频设备所采用。-The main use of variable f
  3. 所属分类:Project Design

    • 发布日期:2017-03-29
    • 文件大小:173931
    • 提供者:wangwang
  1. protel99-module

    0下载:
  2. Driver.ddb Mydot.ddb Wait.ddb 单片机.ddb 电源指示灯.ddb 仿真示例电路.ddb 脉宽调制信号控制电路.ddb 图3-5.ddb 图3-6.ddb 稳压电源电路.ddb 修改74LS373.ddb-Driver.ddbMydot.ddbWait.ddb Singlechip. Ddb power indicator. Ddb circuit simulation examples. Ddb PWM signal cont
  3. 所属分类:Project Design

    • 发布日期:2017-04-09
    • 文件大小:2396449
    • 提供者:俞伯阳
  1. bq27500

    0下载:
  2. bq27500电源控制管理 bq7500德州仪器监测电源剩余电量的最新芯片-bq27500 power control and management of Texas Instruments bq7500 monitoring power consumption remaining the latest chip
  3. 所属分类:source in ebook

    • 发布日期:2017-03-24
    • 文件大小:2545
    • 提供者:林豆
  1. 89s52_serl

    0下载:
  2. 基于89s52的c51串口通信源程序 串口的4种工作方式对应着三种波特率模式: 对于工作在方式1和方式3,波特率由定时器/计数器1T1的溢出率和SMOD(PCON(电源控制寄存器)D7位)决定,-Based on the C51 serial communication 89s52 source of the four kinds of serial work corresponds to the baud rate of three modes: Mode 1 for the w
  3. 所属分类:SCM

    • 发布日期:2017-04-06
    • 文件大小:1202
    • 提供者:
  1. danpianji_xiangguanwaiweidianlutu

    0下载:
  2. 几个实用的单片机外围电路,包括脉宽调制信号控制电路,稳压电源电路,仿真示例电路等,对初学单片机很有参考价值。-Several practical single-chip peripheral circuits, including the pulse width modulation signal control circuits, regulated power supply circuit, simulation, etc. Examples of circuits for beginner
  3. 所属分类:SCM

    • 发布日期:2017-05-10
    • 文件大小:2382091
    • 提供者:小李
  1. kcsj

    0下载:
  2. 课程设计。 1.稳压直流电源的产生 2.温度采集部分 3.温度控制部分 4.温度测量及显示 -Curriculum design. 1. Regulated DC power supply selection of 2. Temperature Collection Part 3. Temperature Control 4. Temperature measurement and display
  3. 所属分类:File Formats

    • 发布日期:2017-04-06
    • 文件大小:689820
    • 提供者:许珂
  1. temperature

    2下载:
  2. STC12C5412AD做的温度检测控制的原理图.有AD检测,可控硅过零触发,开关电源.-Detect STC12C5412AD make the temperature control schematic. Have AD detection, zero crossing triac trigger, switching power supply.
  3. 所属分类:SCM

    • 发布日期:2015-08-14
    • 文件大小:133128
    • 提供者:terence
  1. AN144SW

    0下载:
  2. CP210的手册和vc编程对设备查找电源控制等进行编程-CP210 and vc programming manual search of equipment such as power control program
  3. 所属分类:Windows Develop

    • 发布日期:2017-03-29
    • 文件大小:152312
    • 提供者:wenzhao
  1. Idle

    0下载:
  2. lpc2103开发板上电源控制及睡眠模式-LPC2103 development board power control and sleep mode
  3. 所属分类:SCM

    • 发布日期:2017-04-24
    • 文件大小:37939
    • 提供者:LINKUN
  1. DCPOWER

    0下载:
  2. 51单片机控制简易数控直流电源源码加仿真。-SCM 51 CNC simple DC power source and simulation.
  3. 所属分类:Embeded-SCM Develop

    • 发布日期:2017-04-25
    • 文件大小:223710
    • 提供者:虞厶
  1. dianyuan

    0下载:
  2. 给出了一种以AT89S51单片机为核心, 并通过控制比较调整单元基准电压的变化来 来实现高可靠、小纹波和高精度电压控制的直流数显可调稳压电源的硬件电路组成和软件设 计流程。-To give a single-chip AT89S51 as the core, and by controlling the voltage comparison unit adjust to the changes to achieve high reliability, small ripple and h
  3. 所属分类:SCM

    • 发布日期:2017-04-09
    • 文件大小:66338
    • 提供者:mama
  1. power

    0下载:
  2. 数字电源控制,128*64液晶驱动显示.-Digital power control, 128* 64 LCD display driver.
  3. 所属分类:SCM

    • 发布日期:2017-04-01
    • 文件大小:4814
    • 提供者:冷枫
  1. SolarBox

    0下载:
  2. 利用ATTINY26 mcu开发的一款太阳能电源箱的程序,对太阳能板及电池电量的检测和控制。当电量较低时,发出声光报警并切断输出。-ATTINY26 mcu development of the use of a solar power supply box procedures, solar panels and battery power detection and control. When the electricity is low, the issue of sound and li
  3. 所属分类:SCM

    • 发布日期:2017-04-24
    • 文件大小:11157
    • 提供者:suwei
  1. ex8_PWM

    0下载:
  2. DSP中用于实现PWM来控制电机、开关电源等-DSP implementation PWM used to control motors, switching power supply, etc.
  3. 所属分类:DSP program

    • 发布日期:2017-04-24
    • 文件大小:23949
    • 提供者:刘奇
  1. multifunctionaldigitalclock

    0下载:
  2. 本设计采用一块单片机(AT89S52)作为多功能数字钟的控制核心,加以温度传感器、红外接收管、蜂鸣器、液晶显示器(LCD1602)、电源电路及其他电路构成。实现了时间设置、闹铃设置、闹铃开和关的功能;LCD显示小时、分钟,有AM、PM指示灯,闹钟就绪灯,闹钟到点蜂鸣器报警,220V供电基本功能。另外,本设计还实现了通过切换键盘显示现场温度,红外停止闹铃的功能。 -This design uses a single chip (AT89S52) as the core controller o
  3. 所属分类:Embeded-SCM Develop

    • 发布日期:2017-04-02
    • 文件大小:62550
    • 提供者:侯侠
  1. X_ray_control

    0下载:
  2. 控制X射线和高压源的典型应用程序,包括经典的串口数据处理。-Control the source of X-rays and a typical high-pressure applications, including the classic serial data processing.
  3. 所属分类:Com Port

    • 发布日期:2017-04-25
    • 文件大小:87159
    • 提供者:张铭洋
  1. abc

    0下载:
  2. 无线电源控制系统接收和发射程序 主要是无线电源电路的设计中的程序-Wireless power supply control system for receiving and launching process is the design of wireless power circuit of the procedures
  3. 所属分类:Other systems

    • 发布日期:2017-04-25
    • 文件大小:18807
    • 提供者:xl
  1. PWMSound

    0下载:
  2. 脉冲宽度调制(PWM)是英文“Pulse Width Modulation”的缩写,简称脉宽调制。它是利用微处理器的数字输出来对模拟电路进行控制的一种非常有效的技术,广泛应用于测量,通信,功率控制与变换等许多领域。一种模拟控制方式,根据相应载荷的变化来调制晶体管栅极或基极的偏置,来实现开关稳压电源输出晶 体管或晶体管导通时间的改变,这种方式能使电源的输出电压在工作条件变化时保持恒定。  脉冲宽 -Pulse width modulation (PWM) is the English &qu
  3. 所属分类:matlab

    • 发布日期:2017-04-04
    • 文件大小:615
    • 提供者:fanchao
  1. NCDCcurrentsource

    0下载:
  2. 采用51系列单片机为控制核心,包括电源变换处理及分配模块,恒流源模块,单片机主控模块,键盘输入模块,LCD显示模块,数模/模数转换模块,语音模块和实时时钟模块的9个部分。通过键盘设定好需要输出的电流值后,单片机对设定值按照一定的算法进行处理,经数模输出电压控制恒流源电路输出相应的电流值-51 Series single-chip microcomputer used for the control of the core, including the processing and distrib
  3. 所属分类:SCM

    • 发布日期:2017-04-17
    • 文件大小:170490
    • 提供者:cwyctz
  1. wxdy

    0下载:
  2. 无线电源控制系统,非常实用,经过实验验证了的-Wireless power control system, very useful, after experimental verification of the
  3. 所属分类:SCM

    • 发布日期:2017-04-14
    • 文件大小:4155
    • 提供者:cgroad
« 1 2 3 45 6 7 8 9 10 ... 44 »
搜珍网 www.dssz.com