搜索资源列表
2
- 本程序是以MSP430单片机通过串口向PC机发送4X4矩阵键盘的键值C语言程序,打开串口调试助手,正确设置通信格式,按动4X4矩阵键盘任意一个按键,观察屏幕显示的按键键值-This procedure is based on MSP430 single chip microcomputer to the PC through a serial port to send 4 x4 matrix keyboard key values of C language program, open the
CHECK
- 本迷宫小汽车选用8位STC90C52单片机为控制器,通过3个红外光电传感器E18-D80nk对信号进行采集,采集到的信号经串口转换MAX232CPE处理后传给STC90C52单片机,经单片机处理后,发出控制命令给L298N,驱动2台直流电动机进行相应的动作。该小车实现了前进、后退、左右转弯、避障以及显示运行时间等基本功能,整个系统结构简单,可靠性高,实验测试结果满足要求-STC90C52 microcontroller pass the maze of car use 8 STC90C52 si
112081125
- 是一个接口实验,下位使用单片机控制AD采集数据,通过串口上传数据到vc++编写的上位机,实现波形显示,并有下位机的pcb版原理图和pcb图-Is an interface experiment, bit microcontroller control AD data acquisition, prepared PC through the serial port to upload data to vc++, waveform display, and the mac
BluetoothCOM
- 安卓手机通过蓝牙与单片机(外接蓝牙模块)进行串口通信的小程序,已经调试通过。-Android phones via Bluetooth and SCM (external Bluetooth module) for serial communication procedures, debugging has been passed.
diannaoyaokong
- 单片机C程序,通过串口与电脑连接,用遥控器控制电脑-Single-chip C connected to the computer through the serial control a computer with a remote control
MCU-Serial-receive-data
- 通过串口助手要接受字符串或一组数据需要在单片机端开辟一个缓冲区,否则可能丢失数据。以下程序是较为通用的串口收发例程,开辟一个16字节的缓冲区,两个指针,一个存数指针,一个取数指针,两指针相等,证明没有新的接收数据。-To accept a string or a set of data through the serial port assistant on the microcontroller side to open up a buffer, or data may be lost. Th
between-PC-and-MCU-based-on-USB
- PC机向单片机发送一串数据,然后由LCD显示出来,且发送的数据返回PC机显示,通过串口通信助手-The PC to the microcontroller to send a bunch of data, and then by the LCD display, and send data back to the PC through the serial port communication assistant
A-serial-port-to-send-and-receive
- 此代码为STM32单片机的串口发送与接收的代码,可通过串口小工具来验证调试,经过验证切实可行。-This code for the STM32 microcontroller serial port to send and receive the code, can through the serial port small tool to verify the debugging, proven feasible.
chuankou
- 通过c语言,对单片机rs232串口进行编程,实现pc机与单片机的双向通讯-failed to translate
uart
- 实现了串口通信的功能,通过串口实现单片机和pc的双向通信-failed to translate
stm32usart1receivedandsend
- stm32f103zet6,通过串口1实现单片机与电脑串口助手的接收与发送通信。-With the computer via a serial port 1 to realize single chip microcomputer serial assistants receive and transmit communication.
LED-flashing
- 51单片机实现甲机通过串口控制乙机LED闪烁并通过proteus仿真-51 microcontroller is a machine via a serial port control b LED flashing and through the proteus simulation
single-chip-microcomputer-and-PC
- 51单片机实现单片机与PC机串口通讯仿真并通过proteus仿真-51 singlechip microcomputer simulation and single-chip microcomputer and PC serial communication by proteus simulation
R8C_25_UART
- 瑞萨单片机的R8C/25,UART0通讯程序,可以通过串口与PC机传输接收数据。-R8C/25 UART0
GPS_msp430_code
- 430单片机,程序的功能是通过串口0以4800,n,8,1的通行格式接收GPS数据,之后将 数据进行解析再通过串口1以4800,n,8,1的通行格式发送到PC机,其中数 据打包发送格式为GPS_DATA_PACKAGE:经度,纬度,速度,航向,水平高度, 海拔高度,卫星,年/月/日,时-分-秒(实际连调时这个数据包由GSM模块直 接发送到后台,在由后台再进行处理得到预期的效果)-The functions of the program through the serial por
MFC-serial-display-
- MFC串口显示温湿度,能够与单片机通信,测试通过。可以用上无线-MFC serial display temperature and humidity through Communication with the microcontroller test. Can be used for wireless
51Uart
- 51单片机与PC 通讯,通过串口相互收发数据-51 MCU and PC serial communication
ATMAGEA16-COM-DOWNLOAD
- 通过调用bootloader 实现通过串口给AVR单片机发送程序。-AVR microcontroller through the serial port to send a program by calling the bootloader.
yoghourt
- Atmega8单片机连接18B20温度芯片的代码,ICC AVR开发,C语言。将18B20测到的温度通过串口发送出去。-The ATmega8 microcontroller connected 18B20 temperature chip code, ICC AVR development, C language. The temperature of the the 18B20 measured to be sent through the serial port.
51comdianpian
- 串口发送任意字符到单片机 单片机通过P0口LED灯显示 比如 发送16进制的 00 单片机的LED灯全亮 发送FF灯全灭 首先 烧写程序到单片机 晶振 11.0592MHZ 连接好串口线 打开串口调试软件 选择好COM端口 设置波特率为960-Serial port to send any character to the single-chip microcontroller through the P0 port LED i