搜索资源列表
遗传算法优化simulink中PID参数
- 利用matlab编写基于遗传算法优化PID控制器(Matlab programming PID controller)
DSB的Matlab调制解调仿真
- 利用Matlab/Simulink构建DSB调制与解调系统模型，包括信号源，调制器、信道、解调器及示波器等，观察记录仿真波形，并进行仿真分析
宽带无线仿真
- 宽带无线通信仿真，有关于瑞丽信道建模，导频信道估计，理想信道估计，最大比合并与等增益合并，直接序列扩频(matlab,simulink,STBC,VBLAST)
MATLAB航天姿态控制仿真程序
- 航天器姿态控制仿真程序，利用simulink中sfunction方法建立航天器姿态动力学模型和运动学模型，利用linmod对非线性模型线性化。(The simulation program of spacecraft attitude control uses the sfunction method of Simulink to establish the dynamic model and kinematic model of spacecraft attitude, and uses li
AccCyl
- Acc Cyl matlab simulink example
BLDC 完整
- BLDCM的simulink模型，电流、转速双闭环控制的无刷直流电动机系统，电机模块是自己封装而成的不是用的永磁同步电动机或者自带的BLDCM，所涉及的三个程序也有展示。(The model of BLDCM, the BLDCM system with double closed-loop control of current and speed,and the motor module is a self packaged permanent magnet synchronous motor
基于simulink的16QAM的调制解调
- 基于matlab中的simulink，进行16QAM的仿真搭建。包括了基带信号发生器，串/并模块，模块1，载波调制模块，高斯白噪声信道，模块2，误码率计算器等，能够较好地实现16QAM的调制解调。(Based on the Simulink of MATLAB, the simulation of 16QAM is built. It includes baseband signal generator, serial / parallel module, module 1, carrier m
3.PR单相光伏逆变并网
- 用MATLAB/SImulink 搭建的单相光伏并网逆变器仿真，用PR电压环控制器进行控制，包含2012-2018所有版本(Simulation of single-phase photovoltaic grid connected inverter built by Matlab / Simulink, controlled by PR voltage loop controller, including all versions of 2012-2018)
汽车悬挂设计matlab
- 1.被动悬挂设计simulink模型 2.对于任意一段路面谱，求出其功率谱密度与频率的分布关系，在标准路面图中画出曲线验证路面 3.积分白噪声法路面构造simulink模型 4.整车平顺性分析simulink模型 5.实际路谱案例，c级路面 6.悬架动载荷功率谱密度图像画图matlab编程(1. Simulink model for passive suspension design 2. For any section of road spectrum, the
双向dcdc matlab仿真模块
- 基于matlab中simulink模块箱的双向dcdc仿真程序(Simulation program of bidirectional dcdcdc based on Simulink module box in MATLAB)
4498135
- 使用MATLAB/SIMULINK分析简单电力系统的小信号（低频振荡）稳定性，研究内容如下： 1）使用SIMULINK建立系统的仿真模型。 2）分析比较有无AVR、PSS对小信号稳定性的影响。 3）分别画出针对励磁机增益KA和PSS增益KSTAB的根轨迹图，分析总结增益KA和KSTAB对小信号稳定性影响的规律。 4）仿真在电压参考值5 阶跃变化情况下有无PSS时的转速响应。(Using MATLAB/SIMULINK analysis of a simple power system small
粒子群算法优化pid源码 matlab仿真
- 粒子群算法（PSO）整定pid控制参数，比传统Z-N整定方法要好，内附matlab程序与simulink模型(Particle swarm optimization (PSO) is better than traditional Z-N tuning method in tuning PID control parameters. It includes matlab program and Simulink model.)
boucwen_2story_
- 此boucwen滞回模型建立在matlab-simulink仿真基础上(The boucwen hysteresis model is based on matlab-simulink simulation)
example
- 此模型是基于MATLAB-simulink，用boucwen滞回模型分析单自由度体系的振动反应(This model is based on MATLAB-simulink. The boucwen hysteresis model is used to analyze the vibration response of a single-degree-of-freedom system.)
PMSGWind
- 以直驱式永磁同步风力发电机为研究对象，在Matlab/simulink平台建立了风力机模型、传动系统模型，采用变桨距控制。(Taking the direct drive permanent magnet synchronous wind turbine as the research object, the wind turbine model and the transmission system model are established on the MATLAB / Simulink
锂离子电池一阶等效模型的参数估计
- 锂离子电池一阶等效模型的参数估计，MATLAB/simulink(Lithium-ion battery 1rc equivalent circuit model-MATLAB/simulink)
pid控制永磁电机
- 基于matlab/simulink永磁同步电机的模糊PID控制仿真模型，适用于永磁同步电机，仿真效果还可以(The fuzzy PID control simulation model based on MATLAB / Simulink is suitable for PMSM, and the simulation effect can also be)
SCPC
- SCPC语音传输链路，simulink链路仿真(SCPC voice transmission link)
SIMULINK仿真模型
- 反激式变换器，使用SIMULINK搭建，Matlab版本为2014b，运行正常(Flyback converter, built with Simulink, matlab version 2014b, normal operation)
matlab仿真PID参数整定 源代码+仿真图
- 用MATLAB仿真PID控制，其中用simulink建仿真模型，用matlab语言编写PSO算法用于优化PID参数整定。(Matlab is used to simulate PID control, in which Simulink is used to build simulation model, and PSO algorithm is written in MATLAB language to optimize PID parameter setting.)