搜索资源列表
modbus51_c
- modbus RTU 的C51程序 单片机89S52 通信波特率 9600 8位数据 1位停止位 偶校验 485通位接口-Modbus RTU procedures C51 microcontroller communication baud rate 89S52 9600 8-bit data a dual-stop check-bit interface 485
modbusRTU
- modbus RTU 的C51源程序,单片机89S52,编译器keilC7.06
modbusM16
- modbus RTU 的AVR单片机C语言程序。 单片机mega16,编译器ICCAVR。-modbus RTU source code with atmel avr mcu,c styel,mcu is mega16,compliter use ICCAVR
Modbus_RS485_test
- 这个程序是单片机与PC之间,使用MODBUS的RTU方式进行通信的测试程序,在PC机上需要安装modbus poll软件。-This program is a test program between the MCU and PC, using MODBUS RTU mode communication modbus poll software needs to be installed on a PC.
mmoddbusM116o
- modbus RTU 的AVR单片机SCMC语言程序源码。 单片机机SCMmega16,编译器ICCAVR。 -modbus RTU of the AVR SCMC language program source code. The microcontroller the machine SCMmega16 compiler ICCAVR.
8051_MODBUS_RTU
- 用STC89C58单片机做的数据采集和控制,12位AD转换使用TLC2543,通讯协议采用MODBUS(RTU),通过拨码开关改变从机地址,支持模拟量或数字量的读写。(4路模拟量输入、6路开关量输出(继电器输出)、8路开关量输入).-To do STC89C58 SCM data acquisition and control, 12 AD converter TLC2543, communication protocol MODBUS (RTU), to change the slave ad
MyModbus
- Modbus-RTU通讯协议单片机测试软件,编译通过的-Modbus-RTU communication protocol chip testing software, compiled by the
modbus-51mcu-keil2
- MODBUS RTU 51单片机通信程序,内带上位软件-MODBUS RTU 51 single-chip communication procedures, which take place software
dt.STM32Pfreemodbus
- STM32单片机freemodbus的移植,主从机的都有-1, transplant FreeModbus1.5 and RT-Thread1.1.1 to STM322, development platform supports Eclipse, Keil, IAR3, can be used in the Eclipse plug-in version management EGIT 4, support Modbus RTU (ASCII untested)
MODBUS-RTU
- 组态王与多单片机基于modbus总线协议的例程。-KingView and multi-chip bus protocol modbus-based routines.
MODBUS-C-program-on-51MCU
- 在51单片机上实现工业ModBus通讯协议,RTU协议。包括主机的C程序和从机的C程序。可在PROTEUS仿真软件上运行通过。提供仿真原理图。-Industrial ModBus protocol on 51 single, RTU protocol. C program includes a host and slave C program. PROTEUS simulation software can be run on the pass. Provide simulation schem
MODBUS-CommunicationProtocoCode
- 51单片机MODBUS通信协议RTU方式源码,可以参考着-51 single MODBUS RTU mode communication protocol source code, you can refer to the look
MODBUS
- C语言写的 STC单片机的MODBUS RTU程序,实现了 03 读单寄存器和多寄存器。06写单寄存器功能.-C language to write the STC MCU MODBUS RTU procedures, to achieve the 03 read a single register and register. 06 write a single register function.
main
- 单片机与组态王modbus rtu多机通讯程序-SCM and Kingview modbus rtu multi-machine communication program
test
- 完成PC串口转TTL电平连接485芯片跟多单片机485接口连接;底层通信协议遵循MODBUS RTU规约,要求支持MODBUS协议基本指令,自行制定具体通信协议;根据系统各模块的需要编写模块的功能程序; -Complete PC serial port to transfer a TTL level connecting 485 chip connected with the SCM 485 interface bottom communication protocol Modbus RT
多合一code
- 采用51单片机作为主控制器,通讯方式为485总线,通讯协议为Modbus,波特率为9600,8位数据,1个停止位,无校验位; 本程序作为从机部分编写的;(Using 51 single-chip microcomputer as the main controller, communication mode is 485 bus, communication protocol is Modbus, baud rate is 9600, 8 bit data, 1 stop bits, no pa
main
- 使用stc单片机实现的modbus协议的30路继电器控制(Using stc microcontroller to achieve the modbus protocol 30 relay control)
STM32F103上移植FreeModbus V1.6 RTU
- 在KEIL-MDK平台下,一步一步的搭建freemodbus移植到STM32F103单片机。主要讲解了哪些文件直接拷贝,不做任何修改;哪些移植的文件需要修改以及如何修改,修改过程中注意事项,最后提醒移植到MODBUS-RTU模式下应该注意的事项。(Under KEIL-MDK platform, freemodbus is built step by step and transplanted to STM32F103 single chip computer. This paper mainl
Modbus从站_c51
- Modbus从站_c51 51单片机 MODIBUS RTU 从站程序(Modbus slave station _c51 microcontroller MODIBUS RTU slave station program)