搜索资源列表
DES
- 基于ST7单片机，以DES算法的ST7单片机实现程序。-ST7-based single-chip, to DES algorithm ST7 MCU procedure.
an1046
- describes a technique for emulating an RS232 UART with the ST7 timer without any additional hardware. Only two pins are required for the serial communication.
e2prom
- st7芯片和24c16 iic通訊實例-iic communications
2001OCT02_MEM_MPC_AN2086
- st7 I2C communication
ICPII_schematic
- IPC II cable schematics for programming ST7 family
stepmotor
- 利用ST7F234的PA口驱动步进电机；利用定时器输出比较功能定义了1ms时间来定义步进电机1个pluse时间驱动步进电机正转、反转的代码-Driver function for step motor by using timer function of ST7 to drive on port A
lcd
- ST7 向HT1621B LCD控制芯片发送指令的函数-Control HT1621B by ST7
delay
- 利用ST7定时器输出比较功能定时1ms，定义几个全局变量，做的一个延时比较准确的delay函数，输入1000，就是1000ms-by using ST7 timer OCMP function to define 1ms and created several global variable to get accurate delay function.
remote
- 利用ST7定时器的输入捕获功能采集红外接收器OUT端数据的程序；控制码和遥控器上温度码根据功能选项分开传送-by ST7 timer ICAP function to get IRA out data
BLDC_3PH_SR_2.0
- BLDC 带传感器的电机控制 ST7 直流无刷电机控制程序-BLDC st7
pwm
- 利用ST7单片机的PWM中断，发送PWM信号-Send a PWM signal using an ST7 MCU
an972
- present a basic software driver to emulate a master SPI full duplex communication through standard ST7 I/O ports.
ks0108lib
- font5x8.h graphic.c graphic.h KS0108.c KS0108.h KS0108-8051.c KS0108-AT91.c KS0108-AVR.c KS0108-LPC.c KS0108-PIC16.c KS0108-ST7.c KS0108-STM32.c
gdb
- GDB for STM8 / ST7 Architecture
ae_kqueue
- 编辑器是ST7 此为十蝶三阳CDCdriver! 本人调试多时使用情况良好,现在和大家分享! -Editor is ST7 This is the ten butterfly Sanyang CDCdriver! I debug for many times in good condition, and now share with you!
en.stvd-stm8
- STM8的stvd开发工具4.3.11，对于开发STM8 MCU的开发者使用(ST Visual Develop for developing ST7 and STM8 applications)