搜索资源列表
-
0下载：
2407原理结构，应用。包括：数字输入输出模块；事件管理器模块；数模转换模块；串行外设接口模块；串行通讯接口模块；局部控制器模块；应用模块-2407 Architecture, Application. Including : digital input-output module; Event Management module; ADC module; Serial Peripheral Interface module; Serial Communication Interface mod
-
-
0下载：
Serial Peripheral Interface (SPIV3) Block Descr iption
The SPI module allows a duplex, synchronous, serial communication between the MCU and peripheral
devices. Software can poll the SPI status fl ags or the SPI operation can be interrupt dr
-
-
0下载：
流接口驱动程序是动态连接库，由一个叫做设备管理程序的特殊应用程序加载、管理和卸载。所有流接口驱动程序使用同一个接口并调用同一个函数集，流接口函数。
流接口驱动程序是为连接到基于Windows CE平台的外围设备设计的。这些外围设备包括：
调制解调器、打印机、PC卡等
所有这些外围设备都必须通过外部连接器如串行口或PC卡插槽等连接。
-Stream interface driver is a dynamic link library, called the device man
-
-
0下载：
Serial Peripheral Interface Intro.
-
-
0下载：
卫星导航硬件接收机外围接口UART232串口驱动程序-Satellite navigation hardware the receiver Peripheral Interface UART232 serial driver
-
-
0下载：
经过验证可用.基于CY7C68013的固件源程序；Cypress Semiconductor公司的EZ－USB FX2是世界上第一款集成USB2.0的微处理器，它集成了USB2.0收发器、SIE（串行接口引擎）、增强的8051微控制器和可编程的外围接口-Proven available. Based on the CY7C68013 firmware source Cypress Semiconductor' s EZ-USB FX2 is the world' s first t
-
-
0下载：
// Serial Peripheral Interface (SPI)
// The VSPI core implements an SPI interface compatible with the many
// serial EEPROMs, and microcontrollers. The VSPI core is typically used
// as an SPI master, but it can be configured as an SPI slave as
-
-
0下载：
SPI串口的内核实现verilog语言和VHDL语言-The serial peripheral interface spi bus
-
-
0下载：
FPGA时序逻辑设计：串行外围设备接口SPI从设备系统，包括串行时钟线SCK，主机输入/从机输出MISO，主机输出/从机输入MOSI和低电平有效的从机选择线SS。环境为Quartus。-FPGA Timing Logic Design: Serial Peripheral Interface SPI Slave Device System Includes Serial Clock Line SCK, Host Input/Slave Output MISO, Host Output/Slave
-
-
0下载：
XAPP800SPICPLD源码参考设计-THIS DESIGN IS PROVIDED TO YOU AS IS . XILINX MAKES AND YOU RECEIVE NO WARRANTIES OR CONDITIONS, EXPRESS, IMPLIED, STATUTORY OR OTHERWISE, AND XILINX SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OF MERCHANTABILITY, NON-INFRINGE
-
-
0下载：
硬件板基于DSP芯片TMS320F2812，通过SPI (Serial Peripheral Interface)口对带协议栈网卡W5500寄存器进行配置，通过网络变压器，RJ45与PC机进行通信，DSP硬件系统通过RS232标准串口与上位机进行通信。(The hardware board of DSP chip based on TMS320F2812, by SPI (Serial Peripheral Interface) and the configuration of the netw
-
-
0下载：
通过Cypress的EZ-USB FX3的SPI接口对Xilinx FPGA进行配置(AN84868 shows you how to configure a Xilinx FPGA over a slave serial interface using FX3 which is the next-generation USB 3.0 peripheral controller.)
-
-
0下载：
这是按单片机（Microcontrollers）是否提供并行总线来区分的。总线型单片机普遍设置有并行地址总线、 数据总线、控制总线，这些引脚用以扩展并行外围器件都可通过串行口与单片机连接，另外，许多单片机已把所需要的外围器件及外设接口集成一片内，因此在许多情况下可以不要并行扩展总线，大大减省封装成本和芯片体积，这类单片机称为非总线型单片机。(This is based on whether a single chip computer (Microcontrollers) provides a
-
-
0下载：
ADS1118例程
ads1118:16bits分辨率
数据通过SPI（串行外设接口）传输。
电源从2v-5.5v(ADS1118 routine
ADS1118:16bits of resolution
data are transferred via a SPI(serial peripheral interface)
power supply ranging from 2V-5.5V)
-
