搜索资源列表
GPIOINPUT
- 这是关于GPIO输入实验，LED 点灯，让小灯一亮一灭，时间可以自由控制-This is the experiment on the GPIO input, LED light, so light a small lamp to eliminate a time be free to control
LED
- 基于LPC2210通过GPIO直接控制8个LED产生流水灯效果-GPIO on LPC2210 through direct control of eight LED lights have the effect of flowing water
GPIO-LED-V1.0_OK
- STM32 GPIO LED OK OK BOARD-STM32 GPIO LED OK OK BOARD
GpioToggle
- 该程序主要是用f2812来点亮LED灯。其中程序中采用了3种方式对Gpio进行操作。-The program is mainly to light LEDs lamp by f2812. Which the program uses three kinds of ways Gpio operation.
Blinker
- Using IAR for GPIO of STM8 to toggle led on PIND3
gpio
- 基于DSP2812，使用GPIO的引脚来控制LED灯闪烁。即控制XF引脚高低电平不断变化。(Based on the DSP2812, the GPIO pin is used to control the LED flashes. The XF pin is constantly changing between high and low levels.)
GPIO
- Blink LED using timer delay in Nuvoton controller
8 led GPIO.X
- start dspic 16 bit, 24fj128
12-GPIO输出—使用固件库点亮LED灯
- STM32点亮LED灯2313122332(The HA is according to the time of the story of the world)
LED KEY
- LPC5411XLED流水灯, 实现轮询闪烁。可以控制闪烁时间，key健。所有LPC82x器件的存储器映射都相同。不同的LPC82x器件支持不同的闪存和SRAM存储器大小。(GPIO registers support up to 32 pins on each port. Depending on the device and package type, a subset of those pins may be available, and the unused bits in GPIO r
实验1 - GPIO驱动LED
- 艾克姆开发板例程，驱动GPIO点亮led(ACM development board routines, drive GPIO to light LED)
STM8S-A01_GPIO基础知识
- 在IAR开发环境下，通过STM8S芯片，控制GPIO点亮LED(Use GPIO light up the LED)
1-GPIO
- 此例程是利用XC886单片机通用IO口实现LED闪烁的实验。(This file contains the Project initialization function.)
MPC5744P_GPIO
- MPC5744的基本GPIO操作，通过按钮控制LED等亮灭(The basic GPIO operation of MPC 5744)