搜索资源列表
gpib1
- 广泛用于示波器上的gpig工业标准接口的计算机编成库-widely used oscilloscope gpig the industry standard interface for the computer organization
sericon
- 一个用VB编写的串口通信程序,用于和嵌入时下位机进行实时通信,并以示波器形式显示出其波形。-a VB prepared by the serial communication procedures, and for the current crew embedded real-time communications, Oscilloscope and demonstrate its waveform.
fenxi
- 我自己做的一点关于串口通信的PC机方面的有关示波器的源代码
HOOK
- 基于串口通讯(通过USB转串口)的示波器界面,必须确定已经连接正确的端口才能进行数据传输。
VB_pc
- 上位机VB界面示波器 可用与自制串口通信 让信号的波形绘制与界面
com1send.rar
- 在Ardence RTX环境下,使用串口定时收发数据,波特率为112500,传输一个字节本身略小于100微秒,定时周期100微秒,即在示波器中可观察到连续不断地传输字节,Ardence RTX in the circumstances, from time to time to send and receive data using the serial port, baud rate to 112,500, transmission of a byte in itself a little l
basic_gpib_write_and_read
- 利用VISA去控制GPIB串口通信,最终实现与频谱仪,电源,示波器等相互之间通信-VISA to control GPIB serial communication, and ultimately with the spectrum analyzer, power supplies, oscilloscopes, and other mutual communication between
rs485
- 操作串口直接进行RS485多机通信的类。单片机下485多机通信很容易,用UART的Bit9即可,Windows下就麻烦得多,Windows下串口Bit9用作奇偶校验,要切换Bit9就要动态改通信格式,而且切换时间要跟得上单片机的us级时间。这个自己写的Class用独立线程、Windows高精度定时器机制,高速切换Bit9,示波器测量,时间在10us左右,已用于门禁系统多年,长时间运行可靠! -Direct RS485 serial port operation multi-machine c
DataLogger2
- 从串口接收数据进行实时描点,类似示波器。可进行存储。对学习绘制波形图有很好的帮助。-Receive data from serial real-time tracing point, similar to the oscilloscope. Can be stored. Draw waveform of learning has a very good help.
shiboqi
- 实现函数发生器产生的波形能够在电脑显示器上显示。函数发生器通过GPIB卡与电脑连接并传输数据,电脑上通过LABVIEW软件环境完成与GPIB卡的数据通信。在LABVIEW环境下完成了对虚拟仪器前面板以及后台程序框图的设计与编程。在LABVIEW开发环境下,实现对GPIB控制时,采用VISA模块驱动的方法进行编程。设计结果在LABVIEW环境下的虚拟示波器能够实现示波器的功能,能够显示函数发生器所产生的任意波形。- achieve the waveform can be displayed on
Oscilloscope546xx
- 用VB和GPIB来控制示波器546XX工作-Using VB and GPIB to control oscilloscopes 546XX work
Serial_Signal_Analysis
- 这是一篇分析rs485信号波形的文档,其中的图片是从示波器上截下来的。通信协议使用的pelco_d。-This is an analysis of the document rs485 signal waveform, in which the picture is cut off from the oscilloscope. Communication protocol used pelco_d.
analogwave
- 模拟记忆示波器的程序设计。在计算机飞速发展的今天。大量实验数据可通过计算机接受。此程序模拟了示波器的作用-Analog memory oscilloscope programming. The rapid development of the computer today. A large number of experimental data can be received through the computer. This program simulates the role of the
chuankou
- 实现PC机与其它设备的串口通信(包括单片机以及示波器等)-PC machines and other equipment to achieve the serial communication (including single chip, and oscilloscopes, etc.)
renyixinhaofashengqi
- 任意信号发生器,像下位机发送数据,使其输出到示波器上,产生波形。-Arbitrary signal generator, such as lower computer to send data, so that the output to the oscilloscope to generate waveforms.
Vdfsdfs
- 串口示波器功能,测试并记录 显示波形 显示峰值-Serial oscilloscope function, test and record the waveform display
DS2009_57600
- 示波器界面。采用串口传递数据。下位机为51单片机。-Osilloscope
Simulation_oscilloscope
- 通过串口实现的模拟示波器,界面很好,功能很全-Achieved through the serial port analog oscilloscope, a very good interface, features a very wide
Display
- 示波器显示 接受串口数据 波形幅值 周期 大小可以调整-Oscilloscope display to accept serial data
Serial_Digital_Scope V2_Cracked
- 虚拟串口示波器,将串口数据画成波形显示,特别适合飞控IMU数据显示(Virtual serial oscilloscope)