CDN加速镜像 | 设为首页 | 加入收藏夹
当前位置: 首页 资源下载 源码下载 嵌入式/单片机编程 搜索资源 - 烟雾 检测

搜索资源列表

  1. uart

    0下载:
  2. 移动通信基站机房环境监控系统。本系统分为发射终端和接收终端两部分。发射终端由AVR高性能8位单片机ATmega8作为控制核心,实现对环境温度、湿度、人体、烟雾和门磁开关等环境因素进行检测,通过蓝牙模块把收集到的数据无线传输到接收终端。接收终端用AVR单片机ATmega128作核心,对接收到的数据进行分析处理并显示,同时在必要的时候把数据储存到片内的EEPROM中。-Mobile communication base station computer room environment monito
  3. 所属分类:SCM

    • 发布日期:2017-03-26
    • 文件大小:34052
    • 提供者:醉清风
  1. jiyuGSMfd

    0下载:
  2. 本系统主要由单片机和GSM短信模块组成,借助最可靠、最成熟的GSM移动网络,以最直观的中文短消息或电话形式,直接把报警地点的情况反映到您的手机屏幕上。它采用主动式红外传感器进行检测,变有形的传统防盗网防盗窗为无形,给火灾时的逃生提供方便。并配备烟雾传感器和燃气泄漏传感器,实现防火、防燃气泄漏的作用。-The System is made up of MCU and GSM Modem. It will display the alarm content in Chinese directly a
  3. 所属分类:SCM

    • 发布日期:2017-03-28
    • 文件大小:175720
    • 提供者:chengzi
  1. Smart-Socket

    0下载:
  2. 智能插座。可定时通断,手动按钮通断。烟雾模块烟雾报警,人体红外热释电检测到人体信号打开液晶背光灯。液晶为VTK3224智能液晶。含防雷模块,电能计量模块-Smart outlet. Can be time-off, manual on-off button. Smoke smoke alarm module, pyroelectric infrared detecting human body' s signal to open the LCD backlight. LCD is VTK3
  3. 所属分类:SCM

    • 发布日期:2017-03-29
    • 文件大小:27795
    • 提供者:stone
  1. FEII

    0下载:
  2. 烟雾报警器源程序,可以检测到无烟时不退出报警。-Smoke alarm source, can be detected when the smoke alarm does not exit.
  3. 所属分类:SCM

    • 发布日期:2017-03-29
    • 文件大小:6484
    • 提供者:高飞
  1. alarm

    0下载:
  2. 吸烟报警器,利用单片机检测烟雾信号,有吸烟马上报警,提示禁止吸烟。-Smoke alarm, smoke detection using single-chip signal, smoking police immediately, suggesting that non-smoking.
  3. 所属分类:SCM

    • 发布日期:2017-04-25
    • 文件大小:201720
    • 提供者:李日辉
  1. control-system

    0下载:
  2. 利用Cerebot MX4开发板作为本系统的核心控制单元,热释电人体红外传感器、光电传感器及烟雾传感器构成检测单元,键盘和液晶显示组成人机交互界面,LED报警灯和语音模块为声光报警执行单元,无线收发模块为传感器与Cerebot MX4之间的通讯单元。当检测单元检测到信号时,由检测单元传给控制单元,控制单元进行分析和处理并控制声光报警执行单元产生声光报警,同时将实时信号由GSM模块以短信的形式发送给指定手机,显示单元实时显示宿舍内的安防情况,通过按键进行主人身份唯一识别控制系统的运行,另外,系统
  3. 所属分类:SCM

    • 发布日期:2017-04-01
    • 文件大小:323098
    • 提供者:集异璧
  1. master-slaver

    0下载:
  2. 实现烟雾报警的主从机程序,主机轮巡检测各端子,有烟雾时主机报警-the master-slaver program of being used to realize the smoke detection ,the master takes turns to check the each terminal node ,when checking the smoke ,then alarm
  3. 所属分类:SCM

    • 发布日期:2017-04-10
    • 文件大小:1408091
    • 提供者:hello-cui
  1. djfhgnv-dklvj

    0下载:
  2. 烟雾传感器,可以用来检测,还可发用来报警,不管是家用还是别的用处都是不错的-Smoke sensor, can be used to detect, and hair can also be used to alarm, whether it is a good home or other useful
  3. 所属分类:SCM

    • 发布日期:2017-04-04
    • 文件大小:346315
    • 提供者:崔丙帅
  1. friearlam

    0下载:
  2. 使用AT89S52单片机,红外传感器,烟雾传感器,DS18B20,LCD1602,Z做的自动火灾检测和灭火系统,本人哈工大威海学生。-Automatic fire detection and extinguishing systems use AT89S52 microcontroller, infrared sensor, smoke sensor, DS18B20, LCD1602, Z do, I HIT the Weihai students.
  3. 所属分类:Other Embeded program

    • 发布日期:2017-04-05
    • 文件大小:140422
    • 提供者:陈硕
  1. eeee_test

    0下载:
  2. gsm模块,有家庭防盗功能,和烟雾检测功能-gsm,it is used in the house.111
  3. 所属分类:Other Embeded program

    • 发布日期:2017-11-27
    • 文件大小:35265
    • 提供者:阿信
  1. danpianji

    1下载:
  2. 院程自动报警系统主要设计一种采用单片机AT89C52为控制核心,检测红外,门磁、烟雾等传感器的信号,通过单片机构成的系统进行处理,并通过公共电话网将报警信息传送到预设的号码,同时进行声光报警,实现家庭安全防范的目的。此系统操作简单,无需重复布线,成本有所降低,实现了远程自动报警,对家庭安全起到了一定保障功能。-The hospital process automatic alarm system to design a microcontroller AT89C52 control of the
  3. 所属分类:Other Embeded program

    • 发布日期:2017-05-13
    • 文件大小:10240
    • 提供者:miqiuso
  1. SMOKE_test

    0下载:
  2. CC2540烟雾报警器模块测试程序 烟雾报警器,检测到烟雾时,GPIO输出高电平,报警消失后,变低电平-CC2540 module test procedures smoke alarm smoke alarm, when smoke is detected, GPIO output high, the alarm disappears, goes low
  3. 所属分类:Other Embeded program

    • 发布日期:2017-11-20
    • 文件大小:647
    • 提供者:赵利英
  1. JCSD

    1下载:
  2. 基于nRF4010的烟雾检测系统,具有自动控制功能,此部分为检测发送部分程序,已用过,具有一定参考价值-Based on nRF4010 smoke detection system with automatic control functions, sending part of this part of the test procedures have been used, with some reference value
  3. 所属分类:Embeded-SCM Develop

    • 发布日期:2017-05-13
    • 文件大小:1024
    • 提供者:张辉
  1. intelligent-wireless-alarm-system

    0下载:
  2. 本文介绍了一种操作方便!运行可靠的智能型无线报警系统"它集防盗贼入侵!防火灾!防 有害气体泄露等功能于一体,可实现自动检测和电话自动报警"自动检测是指由各种复合式探测 器或传感器实现对住宅的各种模拟信号(人体发出的红外信号!温度!烟雾浓度!有害气体浓度 等)进行自动监测,复合式传感器的应用使得系统可靠性增强"自动电话报警是指系统通过电话 线路自动拨打户主或相关部门的电话,发出语音求救信号"智能探测器在监测到灾情时只输出报 警信
  3. 所属分类:单片机(51,AVR,MSP430等)

    • 发布日期:2014-02-24
    • 文件大小:2599223
    • 提供者:陈花花
  1. yanwubaojing

    0下载:
  2. 利用红外传感器检测烟雾,如果浓度过高就开始报警,起到防火的作用-Infrared sensor detects smoke, the alarm if the concentration is too high to start, play a role in fire
  3. 所属分类:Embeded Linux

    • 发布日期:2017-04-08
    • 文件大小:25283
    • 提供者:杨先生
  1. JCSD

    0下载:
  2. 基于nRF4010的烟雾检测系统,具有自动控制功能,此部分为检测发送部分程序,已用过,具有一定参考价值-Based on nRF4010 smoke detection system with automatic control functions, sending part of this part of the test procedures have been used, with some reference value
  3. 所属分类:Embeded-SCM Develop

    • 发布日期:2017-04-11
    • 文件大小:1386
    • 提供者:cerpri
  1. 1111

    0下载:
  2. 智能控制温度,湿度,烟雾检测,报警.可以通过手机短信控制,-Intelligent control of temperature, humidity, smoke detection, alarm can be controlled via SMS,
  3. 所属分类:SCM

    • 发布日期:2017-04-14
    • 文件大小:4374
    • 提供者:伤心
  1. JCSD

    0下载:
  2. 基于nRF4010的烟雾检测系统,具有自动控制功能,此部分为检测发送部分程序,已用过,具有一定参考价值-Based on nRF4010 smoke detection system with automatic control functions, sending part of this part of the test procedures have been used, with some reference value
  3. 所属分类:Embeded-SCM Develop

    • 发布日期:2017-04-12
    • 文件大小:1426
    • 提供者:asacoup
  1. mq2 (2)

    0下载:
  2. MQ135气体传感器对氨气、硫化物、苯系蒸汽的灵敏度高,对烟雾和其它有害气体的监测也很理想。这种传感器可检测多种有害气体,是一款适合多种应用的低成本传感器。据说使用的时候需要预热,我是直接用的。 树莓派 VCC <---> 1 #3.5V GND <---> 6 DO <---> 7(code #!/usr/bin/env python # encoding: utf-8)
  3. 所属分类:单片机开发

    • 发布日期:2018-04-30
    • 文件大小:475136
    • 提供者:嵌入式学习
  1. STM32_DHT11_OLED

    6下载:
  2. 基于STM32F103C8T6单片机的环境检测系统,应用DHT11温湿度传感器,MQ135烟雾传感器,检测环境温湿度,烟雾,可燃气,检测到烟雾蜂鸣器报警,将实时数据显示在OLED屏上,且有按键可以修改报警值。(Based on STM32F103C8T6 microcontroller environment detection system, DHT11 temperature and humidity sensor and MQ135 smoke sensor are used to det
  3. 所属分类:单片机开发

    • 发布日期:2020-03-13
    • 文件大小:29020160
    • 提供者:冯诺依曼酱
« 12 »
搜珍网 www.dssz.com