搜索资源列表
16X2字符液晶接口程序
- 字符型液晶显示器测试驱动程序，16×2字符，用八位数据线方式- Character liquid-crystal display test driver, 16脳2 character, with eight data lines ways
AT89C51与字符型液晶模块16x2联接的C语言程序
- AT89C51与字符型液晶模块16x2联接的C语言程序-AT89C51 and character liquid crystal module 16x2 joint C language procedure
自编的C51串口程序
- 自编的C51串口通讯程序，在AT89C51上测试运行OK，用22.1M晶振最高可跑115KBPS-directed the C51 serial communications procedures, the AT89C51 OK on the test run, with a maximum 22.1M crystal run 115KBPS
pcf8563t驱动程序
- PCF8563 的驱动程序，用两个普通的IO口模拟I2C总线，包括100KHZ（T=10US）的标准模式选择和400KHZ的快速模式选择，默认11.0592MHZ的晶振-PCF8563 of the driver, with two ordinary analog IO I2C bus, including the extremely low distortion (T = 10US), the standard model selection and 400KHZ fast mode sele
LCD12864串行控制汇编源程序
- 好东西共享给大家,液晶显示的1502的,单片机51系列-something good for everyone to share, the liquid crystal display of the 1502, the 8031 Series 51
BIT TEMP
- 这是关于DS18B20的读写程序,数据脚P2.2,晶振12MHZ 温度传感器18B20汇编程序,采用器件默认的12位转化,最大转化时间750微秒 显示温度00到99度,很准确哦~~无需校正!-DS18B20 on literacy, data P2.2 feet, 12MHZ crystal temperature sensor 18B20 assembler, using the default device into 12, the largest 750 microsecond conve
单片机应用PS2键盘的实例
- 单片机应用PS/2键盘的实例,本程序源码只供学习参考，不得应用于商业用途，如有需要请联系作者。 [注:AT89x51使用12M或11.0592M晶振,实测使用11.0592M] [Keil uV2 7.01编译运行通过 程序中没有做键盘数据的奇偶校验]-SCM application PS / 2 keyboard example, the learning process only reference source, not used for commercial purpose
ZLG7290 I2C接口键盘及LED驱动器C51
- ZLG7290是串口的可以带64个按键,8位数码管显示的芯片,由于它的震荡电路是晶振,所以比7279稳定(7279是RC震荡)-Wire serial port can bring the 64 keys, eight digital display control chip, because it is crystal oscillator circuit shocks, the stable compared to 7279 (7279 was RC concussion)
通过单片机测试显示芯片HT1621与LCD屏
- 通过单片机测试显示芯片HT1621与LCD屏 本例采用89S52, 晶振为11.0592MHZ-through the test chip microcontroller HT1621 LCD screen with the use of 89S52 cases, crystal-11.0592MHZ
12864 LCD图形显示程序例子
- 在LCD上显示一幅图，是“我的电脑，我的文档”。IC用PIC16F877A，晶振4MHZ，采用并行8线，LCD：TS12864-3，接法在程序中有定义，只要将此程序COPY到你的PICC里编译下载后，在目标板上即可以看到图画了！-displayed in the LCD monitor an illustration of the "My Computer, My Documents." IC with PIC16F877A, crystal 4MHZ using eight
GE15
- 同步发电机同步电动机软启动电子开关通用的晶砸管控制程序.-synchronous generator synchronous motor soft-start electronic switch generic crystal smashing control procedures.
at89c51rc编程编程函数
- 此为at89c51rc的编程和校验函数，特此提醒：前16K比后16K编程速度要快，此程序晶振为16M。-for programming and checking function, and would like to remind : before the 16K than the 16K speed faster programming, this procedure crystal to 16M.
W78E516B-BootLoader
- W78E516B的BOOT程序，将该程序烧写到BOOT区，当启动到BOOT区时，可以通过该程序经串口将系统程序下载到主程序区，晶振为22.1184MHz时波特率可以达到115200bps，比常规烧率器都快！-W78E516B the BOOT process of burning of this program BOOT, When the boot BOOT areas, through the program as a serial port to download system main
93c06
- SPI总线驱动程序 包括的普通封装标准模式,特殊封装标准模式 默认11.0592Mhz的晶振。-SPI bus driver package including the general standard model, special Packaging standard default mode 11.0592Mhz the crystal.
93c06jing
- SPI总线驱动程序 包括的普通封装标准模式,特殊封装标准模式默认11.0592Mhz的晶振-SPI bus driver package including the general standard model, special Packaging standard default mode of crystal 11.0592Mhz
温度控制功能的电子时钟
- 具有温度控制功能的电子时钟” 使用AT89s51单片机12M晶振 具有时间显示和温度控制功能 增加了一个按键进行模式的切换 望大家多多指教-temperature control function is the electronic clock "using AT89s51 SCM 12M crystal significantly with time show and temperature control function added a button for sw
ds18b20(avr_c)
- DS18B20的操作读写源程序（7.3728MHZ晶震）-DS18B20 the source code to read and write operations (7.3728MHZ Crystal Chun)
Delay
- C51单片机常用延时子程序(可根据晶振振荡频率自己调整)-C51 microcontroller used delay subroutine (under crystal oscillation frequency of their adjusted)
softinfrared
- 软件红外线接收驱动程序 *程序功能：软件红外线接收 *晶振：采用24MHz晶振-software infrared receiver Drivers * procedures functions : software infrared receiver * crystal : 24MHz crystal oscillator
MOTOROLA24c02
- 24c02 摩托罗拉8为单片机c语言读写程序 单片机为gt8，晶振9.8304MHz 已经测试过，可放心使用-24c02 Motorola MCU c eight languages to read and write procedures for gt8 SCM, crystal has already tested 9.8304MHz, can be assured use