搜索资源列表
remote
- keil C51编写的遥控器程序，欢迎借鉴。-keil C51 prepared by remote control program, welcome to learn from.
swra305
- CC1110和CC2510的LED灯远程控制程序，本设计建立在CC1110和TPS40211基础之上。-AN080-- LED Lighting with Remote Control using CC2510 and CC1110 This note describes a LED lighting design based on CC2510 and TPS40211. CC2510 is 2.4GHz System-on-Chip Low Power RF Transceiver wh
12864ANDREMOTEKEY
- 遥控键值解码-12864LCD显示,是学习遥控解码,12864LCD很好的资料-Remote key decode-12864LCD show that it is learning remote control decoding, 12864LCD very good information
wl1122
- 一款用2262作无线遥控开关,义隆EM78P153作解码的四路开关单片机程序(可自动生成及发送2262对应密码)-Using 2262 as a wireless remote control switch, Elan EM78P153 microcontroller for decoding the four-way switch procedure (which can automatically generate and send the 2262 corresponding passwo
nrf6905_remote_control
- nordic 24le1直接对芯片进行写入，可以构建一个2.4g遥控器-nordic 24le1 to write directly on the chip, you can build a remote control 2.4g
slaa365
- Clear Channel Assessment Using TI MSP430 and CC2500 Radio-This application report describes a 2.4-GHz anti-jamming frequency-hopping system consisting of a designated Transmitter and Receiver, each with distinct functions to avoid RF-channel interfer
cheng
- 电子无线称重称，51为主芯片。遥控输入。标定，精度高。-Electronic wireless weighing said the 51-based chips. Remote control input. Calibration, high accuracy.
Remote Control
- 红外线遥控控制继电器 MCU:STC89C52 ,晶体频率：11.0592MHz-Infrared Remote Control Relay MCU: STC89C52, the crystal frequency: 11.0592MHz
MSP430F413
- 用MSP430F413单片机实现的智能的无线遥控器的设计，已包含电路原理图和程序源码-MSP430F413 MCU with a wireless remote control of intelligent design, already contains the circuit schematic and program source code
Winamp-IR
- Winamp IR remote control PIC microcontroller
89C51
- 学习型8路红外线遥控开关源程序 晶体为11.0592M,波特率9600bps-Learning 8-channel infrared remote control switch source crystal 11.0592M, baud rate 9600bps
UniversalRemote
- Some universal remote based on PIC16F877 and Nokia 3310 display
wuxian
- 无线遥控小车的程序，分软件和硬件部分。软件已经包括上位机的部分-Wireless remote control car program
IRremote
- arduino使用红外线摇控器时所需的lib，只用一个命令即可使用。-arduino lib, is used to ir remote control.
remote
- 红外NEC遥控接收和处理模块，在51上完全应用通过-NEC remote control infrared receiver and processing module
261107
- This Firmware demosntrate how Incremental Encoder, HD44780U LCD end EEPROM accessing works under BASCOM AVR basic. The Project is just a remote controller for HAM radio antenna matching network device.
Remote Control Signal Analysis Board
- 51制作的红外、315M、433M、遥控信号分析板, 含PCB图，单片机程序，原理图，两大功能：1.红外遥控器—波形采集和编码分析功能。2.无线遥控器（如PT2262、等无线编码遥控）的波形采集，地址码和数据码分析功能。 -51 produced by infrared, 315M, 433M, remote control signal analysis board, including PCB diagram, SCM, schematic diagram, the two major fu
R23
- 这是一个无线遥控程序，使用PIC16F628A制作，能够实现远程无线遥控。-This is a wireless remote control program, using PIC16F628A production, to achieve long-range wireless remote control.
Study_IR_Remote_Control
- 资料包含源码，硬件图，红外相关资料等，本学习型红外遥控器，通过学习一次遥控器的编码，即可脱离原遥控器来遥控电器或者设备，源码很完整，严格测试过，不过由于C52的单片机RAM有限，编码缓冲区长度有限，而不同的遥控器的编码长度也不相同，对于像空调遥控器编码比较长的就会出现学习不了的情况，必须要加外部RAM作为接收缓冲区，或者换用STC的单片机，内部的RAM比较大，不用扩展，用STC还有好处就是不需要外部的eeprom来保存读取的编码，而C52需要用外部的EEPROM来保存编码，这个源码实用的AT24
jianpan
- 数控电源,俄罗斯方块，自行车程序，红外遥控爬虫机器人，混合电压设计-NC power, the Russian box, bike program, infrared remote control robot reptiles, mixed-voltage design