搜索资源列表
1602
- 电子密码锁 单片机8051实现 lcd1602显示 程序分块打包 方便应用-Electronic Code Lock MCU 8051 to achieve lcd1602 display program block packaged to facilitate their application
dianzmma
- 基于c51的8位电子密码锁，可修改密码，lcd显示，有完整的程序和仿真电路图-C51-based 8-bit electronic code lock, can modify the code, lcd display, a complete circuit simulation program and
lock
- 4×4键盘及8位数码管显示构成的电子密码锁-4 × 4 keyboard and 8-bit digital tube display constitutes an electronic code lock
lock
- MSP430F449串行密码锁 MSP430F449 MSP430F449-MSP430F449 serial code lock
51passward
- 单片机开发的电子密码锁，可以设置2个密码。-Developed single-chip electronic code lock, you can set two passwords.
electroniccodelock
- 单片机论文-基于单片机的电子密码锁，论文描述清晰，实现简单。-Single-chip thesis- based on single-chip electronic code lock, thesis describes the clear, easy implementation.
ddddddd
- 两个键的电子密码锁！实验电子电路监控！含蜂鸣器警报！-Two key electronic code lock! Experimental electronic circuit to monitor! With buzzer alarm!
password
- ATmega128单片机C语言实现六位数的电子密码锁-ATmega128 single-chip C language realization of six-digit electronic code lock
lock
- 电子密码锁的程序原包，可以直接使用。是基于51单片机-Electronic code lock procedure the original package, can be used directly. Is based on 51 single-chip
lock
- 4×4键盘及8位数码管显示构成的电子密码锁 用8位数码管组成显示电路提示信息，当输入密码时，只显示“8.”，当密码位数输入完毕按下确认键时，对输入的密码与设定的密码进行比较，若密码正确，则门开，此处用LED发光二极管亮一秒钟做为提示，同时发出“叮咚”声；若密码不正确，禁止按键输入3秒，同时发出“嘀、嘀”报警声；若在3秒之内仍有按键按下，则禁止按键输入3秒被重新禁止-4 × 4 keypad and 8-bit digital tube display constitutes an electr
Electronic_Code_Lock
- 电子密码锁，包含电路图，程序代码，还有红外遥控的解码部分-Electronic lock, including schematics, program code, as well as infrared remote control decoding part of the
lock
- 基于单片机的电子密码锁，使用51单片机，lcd12864-Microcontroller based electronic code lock, using 51 single-chip, lcd12864
passwordLock
- 本数字密码锁采用单片机AT89S52为主控芯片，由EEPROM存储密码。硬件部分包括主控制系统、人机交互界面以及输出系统三大部分。 软件部分应用单片机C语言实现了本设计的全部控制功能。C语言编译方便，易读性好，且移植性方便，能够满足实现本系统的功能要求。在设计过程中，给出了本系统C语言编程的原理和流程图。-The digital code lock using AT89S52 microcontroller as the main chip, the EEPROM stores the pa
code
- 基于郭天祥单片机开发板写的一个密码锁。输入密码正确，则灯亮。可以修改密码。存在的问题是掉电后改过的密码不能保存。-Guo Tianxiang microcontroller based development board to write a code lock. Enter the password correctly, the lights. Can change the password. Problem is powered off, turn over the password can
Electronic-code-lock
- 根据设定好的密码，采用二个按键实现密码的输入功能，当密码输入正确之后，锁就打开，如果输入的三次的密码不正确，就锁定按键3秒钟，同时发现报警声，直到没有按键按下3种后，才打开按键锁定功能；否则在3秒钟内仍有按键按下，就重新锁定按键3秒时间并报警。-Electronic code lock, LCD display with
Microcontroller-based-code-lock
- asm code for pic microcontroller based electronic lock
trick-lock
- 电子密码锁: 可设定从1位到8位的密码，从键盘键入正确密码才可更改密码或开锁。输入三次错误密码电路就不断报警。开锁信号输出口用发光二极管表示。 1．可设置密码，掉电密码能保存； 2．按键确实被按下时发出一下提示音； 3．设置新密码前需校验旧密码； -Electronic code lock: can be set from 1-8 in the password from the keyboard to type the correct password to change
code-lock
- code for code lock in c51 assembly.
electronic-code-lock
- 基于单片机的电子密码锁程序，用Keil软件C语言编写，有断电保护功能-Based on single-chip electronic code lock procedure, with Keil software written in C, there is power protection
Electronic-Code-Lock-Procedure
- 电子密码锁： 系统能完成：开锁、超时报警、超次锁定、管理员退出、修改用户密码基本的密码锁的功能。-Electronic Code Lock Procedure