搜索资源列表
FFT_phase_meter
- 激光测距仪中应用相位法中的相位差检测,应用频域fft算法 -laser rangefinders Application Phase Phase Difference Detection of application frequency domain algorithm fft
tasm
- select evolution with distance of the location of the current point difference, that is, if the current points for the I, the evolution of phase points can only be
Autocorrelation
- 基于labview的多重自相关算法测量低信噪比条件下两路正弦波的相位差-Based on the phase difference between two sine wave labview multi the autocorrelation algorithm measuring low signal-to-noise ratio conditions
Cross-correlation
- 基于labview8.6的FFT法测量低信噪比条件下两路方波信号的相位差，经测试，幅值测量精度和相位测量精度都很高-Based labview8.6 FFT method to measure the phase difference between the two square wave signals in low signal-to-noise ratio conditions, test, amplitude measurement accuracy and phase measurem
Hilbert
- 基于labview8.6的希尔伯特变换高精度测量低信噪比条件下两路正弦波相位差-Labview8.6 based Hilbert transform high-precision measurement of the sine wave phase difference of the two low SNR
ang_continue_measure_ver2.0-
- 5124采集程序，频谱显示，时域波形显示，存储，通道之间的相位差计算-5124 collection procedures, spectrum display, time-domain waveform display, storage, compute the phase difference between channels
phasediff
- 基于谱分析法的相位差计，仪器内集成周期测量仪（基本原理是计数法）-Based on spectral analysis of the phase difference meter, instrument integration cycle measuring instrument (the basic principle is counting method)
phase-difference-detection-based-FFT
- 基于LabVIEW设计了相位差的检测程序，采用相关法、过零法、FFT法、频谱分析法四种方法，适合毕业设计。-LabVIEW design phase of the testing procedures, the use of correlation, zero-crossing method, FFT method, spectral analysis of four methods for graduation design.
phase
- 计算三相电路电压差，使用Matlab M文件-Three-phase circuit voltage difference calculation using Matlab M file
b_point
- GPS测量数据处理可分为基线解算和网平差两个阶段，基线解算就是利用ＧＰＳ接收机接收到的 载波相位观测值做为基本观测值，对其进行差分处理。-GPS data processing can be classified as the baseline solution and flat screen two phase difference, baseline solution is the use of GPS receivers to carrier phase observation value
DPD_Digital-phase-detector
- This the phase difference calculation method based on digital phase detector DPD. It uses Hilbert transform to shift one signal the other by 90 degree. Then by some manipulation, extract the phase difference between two signals.-This the phase diff
phase_difference_with_fft
- The program contains the implementation of phase difference estimation based on fast fourier transform. The Fourier transform is applied on the two signal, after some manipulation the phase difference between the two signal is estimated. This
plv_measure
- this function computes phase synchronization using Phase locking value method over an analysis window of fixed length inputs to this function - phase, sampling frequency output this function - synchronization measure based on PLV processing perform
互相关法相位差测量仪
- 基于labview的互相关法测量相位差计的设计，软件压缩包，可自行下载调试(LabVIEW correlation design method based on phase difference measurement)