搜索资源列表
使用keil C并用PROTEUS仿真
- 使用keil C并用PROTEUS仿真，实现8051单片机对温湿度传感器SHT10数据采集，并使用1602液晶显示。-PROTEUS using keil C and used simulation to achieve 8051 temperature and humidity sensor SHT10 of data collection, and use the 1602 LCD.
SHT10-1602-51
- 温湿度传感器（sht10)和单片机液晶显示源程序。- 翻译： 中文 » 英语 温湿度传感器（sht10)和单片机液晶显示源程序。 Temperature and humidity sensor (sht10) and single-chip LCD source.
MSP430F413-sht10
- MSP430F413 and SHT10 to show T and H useing LCD
S6700-Multi-Protocol-Transceiver-IC
- SHT10温湿度传感器检测值在1602液晶上显示程序-SHT10 temperature and humidity sensors to detect the value displayed on the LCD in the 1602 program
SHT10
- 基于STC89C52驱动温湿度传感器SHT10，并显示在lcd12864液晶显示上-Based on STC89C52 drive temperature and humidity sensor SHT10 and display on the LCD in lcd12864
TEST
- 由SI4432组成无线网络，两个发送，提个接收，发送数据为有SHT10采集而来的温湿度，液晶显示采用1602液晶-Form a wireless network, two sent by the SI4432 to mention the receiver to send data have the SHT10 collected from temperature and humidity, the LCD 1602 LCD
TSHT10-1602-5e
- 温湿度传感器（sht10)和单单片机液晶显示源程序。可直接使用。 -Temperature and humidity sensors (sht10) and a single single-chip LCD display source. Can be used directly.
sht10-
- 基于温湿度传感器sht10的温湿度检测系统，实现了sht10采集现场温湿度信号，通过A/D转换器送至AT89C51单片机，对单片机编程实现在液晶显示屏显示温湿度，并设计了声光报警，由LED灯和蜂鸣器实现。-Detection system based on temperature and humidity, temperature and humidity sensors sht10, temperature and humidity signal sht10 collected at the
SHT10_1
- 用MSP430单片机读取SHT10温湿度数据并在1602液晶上显示-Read the SHT10 temperature and humidity data using MSP430 MCU and LCD display in the 1602
sht10
- AT89C52 与SHT10 和1602液晶测温湿度的程序-AT89C52 and SHT10 temperature and humidity 1602 LCD procedures
controller_keil5
- 使用STM32F107，带有网络端口，嵌入LWIP协议，服务器获取内容解析并执行，同时环境温度、湿度检测，可以控制外部设备动作，使用继电器完成控制，具有外部电平采集功能，高低输入检测。是一个很好的工程产品程序。内容中使用了cjson完成对网络通信内容的传输。-IDE:keil 5 MCU:STM32F107RC Function: connet internet by ethernet port,LCD display ,sht10 temp&humi measurement,rela