搜索资源列表
CC2530-BasicRF
- 注：本例程的源代码CC2530 BasicRF.RAR来源于TI官方网站，用户也可到TI官方网站下载（需注册）。代码解压完成后，请将附件hal_lcd_srf05.rar解压并将hal_lcd_srf05.c文件替换掉..\CC2530 BasicRF\source\components\targets\common\文件夹下的同名文件，同时将hal_lcd.h文件替换..\CC2530 BasicRF\source\components\targets\interface\文件夹下的同名文件。
CC2530-BasicRF
- zigbee网络中基于cc2530的一些基本无线通信实验源代码-zigbee networks based on wireless communication cc2530 some of the basic experimental source code
zigbee
- 基于zigbee的大型停车场设计C代码，包括cc2530发送串口数据，和接收到数据并转成串口给PC上位机。-Large parking lot design based on zigbee C code, including cc2530 send serial data, and convert the received serial data to the PC host computer.
swrc126c
- Zigbee ZStack-2.3.1-1.4.0 (2010/9/1) 最新ZStack Source Code, include HomeAutomaction, Smart Energy, Application Examples-Zigbee ZStack-2.3.1-1.4.0 (2010/9/1) ZStack Source Code, include HomeAutomaction, Smart Energy,Application Examples
swrc135b
- CC2530的源代码，包含一些基本的初始化，和应用实例。-CC2530' s source code, including some basic initialization, and application examples.
CC2530
- 基于ZigBee的CC2530看门狗实验源代码-CC2530 ZigBee-based watchdog test source code
CC2530UART
- 基于ZigBee的CC2530串口基础实验源代码-CC2530 ZigBee-based source code for serial-based experiments
CC2530_test
- CC2530的实验例程代码，打包好了，不用一个一个下载-CC2530 experimental sample code, packaged well, not one by one down!
ZIGBEE
- TI公司ZIGBEE实现的源代码， TI公司ZIGBEE实现的源代码，-TI ZigBee to achieve the company' s source code, TI ZigBee to achieve the company' s source code, TI ZigBee to achieve the company' s source code,
TimacLightV1.1
- cc2530通讯代码，可以试试看，路由器协调器可以进行通信-cc2530 communication code, you can try, the router can communicate coordinator
CC2530-TEST-CODE
- CC2530测试代码，可以实现简单的收和发。-CC2530 test code
CC2530-GSM-code
- 无线单片机CC2530的串口实验和连接GSM模块的实验代码，-some serial and gsm code about wireless mcu cc2530
code-and-document-cc2530
- 此代码适合zigbee学习者入门参考之用，芯片为TI的CC2530，代码包括基础实验(裸跑)及协议栈基础代码，更有项目实战代码如无线考勤机。-This code is suitable for learners entry reference zigbee chip is TI' s CC2530, code includes basic experiments (run naked) and protocol stack based code, the code is more prac
cc2530-code
- 基于zigbee cc2530的模拟输入调试程序，给出了使用cc2530模拟输入所需配置的寄存器。可用。-Based on the analog input debugger zigbee cc2530, gives the desired configuration using cc2530 analog input registers.
cc2530
- 部分传感器在cc2530上的代码，包括dht11，gy30，mg811等-Part of the sensor on the cc2530 code
CC2530协调器源代码
- 协调器代码案例，用于CC2530在IAR下的刷机(Coordinator code case for CC2530 in the IAR brush)
CC2530实验代码教程
- cc2530 的代码及教程 ，内含步进电机程序，RFID射频卡程序、DS18B20温度传感器DHT11温湿度传感器的代码，人体红外传感器代码，MQ-2气体传感器代码等(CC2530 code and tutorials, including stepper motor program, RFID radio frequency card program, DS18B20 temperature sensor DHT11 temperature and humidity sensor code,
1、CC2530 流水灯实验
- 基于CC2530单片机的流水灯实验代码，可参考(Water lamp experiment code based on CC2530 MCU can be used as reference)
03 CC2530单片机基础实验
- CC2530单片机基础实验一些的例程代码(Some routines code for the basic experiment of CC2530 single chip microcomputer)
cc2530-Temp.-and-Hum.-Sensor
- 这是CC2530 zigbee模块关于温湿度传感器DHT11 实验的资料 -代码复制到IDE仿真即可(This is the CC2530 zigbee module DHT11 experiments on temperature and humidity sensor data - code can be copied to the IDE emulation)