搜索资源列表
GPIO
- GPIO (General Purpose Input and Output ports) with microprocessor programmable tri-state bus interface-Use verilog to design a 48 control points that can be programmed to input or output controller
gpio
- dsp程序例子GPIO，在CCS中可以运行-dsp example program GPIO, can be run in the CCS
GPIO
- S3C2440 GPIO 驱动 S3C2440 GPIO 驱动 S3C2440 GPIO 驱动-S3C2440 GPIO
gpio-test
- 1、将makefile中的 CROSS =/usr/local/arm/2.95.3/bin/arm-linux- CFLAGS+=-I/usr/local/src/2.4.18-rmk7/include CFLAGS+=-I/usr/local/src/2.4.18-rmk7/include/linux CFLAGS+=-I/usr/local/arm/2.95.3/arm-linux/include 路径改为你宿主机上的。 2、#make，来编译驱动模块。 3、
GPIO-Output-Control-Experiment-Under-Wince
- 基于wince系统下的GPIO输出控制源代码-GPIO output wince under the control of the source code
GPIO
- WindowCE 下的GPIO输出控制实验原代码-GPIO output WindowCE under the control of the experiment the original code
gpio
- GPIO based on TI F2407
GPIO
- LPC2478的GPIO测试例子，共大家参考-LPC2478' s GPIO test case, a total of reference. . . .
gpio
- gpio using phisical adress pointers
GPIO
- DSP GPIO程序通用输入输出接口 可以外扩其它硬件-DSP GPIO
GPIO
- NXP LPC 2378 GPIO模块例程C语言程序-NXP LPC 2378 GPIO module routines C language program
Gpio
- ARM7下通用GPIO口的使用源代码，包括C语言和汇编-GPIO port general-purpose ARM7 use of the source code, including C language and assembler
GPIO
- 基于5000系列的dsp的gpio控制工程 是过得很有用-Dsp-based 5000 Series of gpio control engineering is a very useful too
gpio
- dsp 2812 gpio 程序,可在开发板上直接运行，并根据需要修改-dsp 2812 gpio devlopment
gpio-i2c
- gpio-i2c 海思平台上3511-3520用io口模拟i2c在linux驱动，里面有很清楚的i2c时序-gpio-i2c Hisilicon platform 3511-3520 simulated with the io port i2c driver in linux, which has a very clear i2c timing
gpio
- coldfire的ETPU模块用于GPIO 基于vxworks-coldfire' s ETPU module for GPIO-based vxworks
GPIO
- STM32的GPIO端口配置需要的下载-STM32 of the GPIO port configuration needed to download! !
GPIO
- 红牛开发板(STM32F103ZET6) GPIO示例程序，开发环境为MDK-Red Bull development board (STM32F103ZET6) GPIO Example program development environment for the MDK
gpio
- 基于dsp（dm642）的最简单的gpio口的驱动程序，可直接运行在csl环境-Based on dsp (dm642) The easiest gpio port driver, the environment can be directly run in csl
Lab0401-GPIO
- DSP例程，基于C54x的GPIO的程序，已经在CCS上调试成功，在这里与大家一起分享-DSP routines, procedures based on C54x the GPIO has been successful in the CCS to debug, to share with you here