资源列表
利用SURFER建立滑坡FLAC3D模型源程序
- 利用SURFER建立滑坡FLAC3D模型源程序(Establishment of FLAC3D Model Source Program for Landslide Using SURFER)
Goaf of Coal mine
- FLAC3D 煤矿采空区命令流用，FLAC 3D 模拟煤矿垮落法和充填开采影响的命令流。-(Command Flow in Goaf of FLAC3D Coal Mine .With FLAC3D simulation of coal caving method and the impact of mining backfill command stream.)
??
- W2 750 full source code tmsrv complete
16apsk
- 16apsk信噪比与误码率的关系曲线 星座图(Constellation diagram of the relationship between signal-to-noise ratio (SNR) and bit error rate (BER) of 16APSK)
APDL成形程序
- 激光熔覆数值仿真温度场的计算，光内送粉形式的激光熔覆(Numerical simulation of laser cladding)
xc8_2.0_2.1破解
- 针对mplab ide的c编译器 xc8 版本v2.0 v2.1 破解文件 亲测好用 解压 按照对应的路径进行覆盖即可(C compiler xc8 version V2.0 v2.1 for MPLAB ide can crack files and overwrite them with decompression according to the corresponding path.)
ProjectH
- 3个绕组分段式永磁直线电机的模型，ansoft,maxwell的仿真文件，具体电机的参数可参看仿真文件。注意：要用18及以上的版本才可以打开(The model of three winding piecewise permanent magnet linear motors, the simulation files of Ansoft and maxwell, can refer to the simulation files for the specific motor parameter
COMSOL_Multiphysics网格剖分用户指南121
- 有限元comsol教程，这东西非常适合初学comsol的新手(Finite element COMSOL course)
stm32f105 CAN通讯
- CAN通讯驱动程序 希望对大家有用 STM32F105使用CAN1 和CAN2一起通讯(STM32F105 CAN RX TXhe double CAN test passes, the CAN1 receives the CAN2 output, and the CAN2 receives the CAN1 output)
STM32F103C8T6原理图
- 基于STM32F103C8的原理设计SDKL ，代表了最新发的设计深刻的vDV就(Principle Design Based on STM32F103C8)
FCM
- 可以测时延，进行平滑，OFDM信号，有效的进行MUSIC算法估计(Can measure delay, perform smoothing, OFDM signal, and effectively perform MUSIC algorithm estimation)
TC358840_870_TD_nonNDA_20160412
- 东芝tc358840+358870全部资料，包括手册，寄存器配置。excel配置表等(Toshiba tc358840 + 358870 all information, including manual, register configuration. Excel configuration table, etc)