资源列表
modemADSl_SE261-driver_VNPT
- o not upload copyrighted content and the file which has trojan or virus
CommMonitor-v3.13
- 主要用于串口监视以及监视系统进程的串口信息-Mainly used for surveillance and monitoring system processes the serial port serial port information
usbcan20110120
- 自己花3个月编写的USB CAN 通讯程序完整版，下位机DSP2812通过CAN总线连接广州志远电子的USBCAN1.0分析仪，上位机通过USB口调用厂家的dll。delphi界面编程涉及到了BDE数据库引擎和DBGrid控件的使用-He spent three months writing the full version of USB CAN communication procedures, lower computer connected via a CAN bus DSP2812 Gu
LabVIEWyutaiketongxin
- 关于labview与泰克示波器的pc通信-About Tektronix oscilloscope pc labview communicate with
LabVIEWandTDS200
- 关于labview与泰克TDs200示波器的pc通信-About Tektronix oscilloscope pc labview communicate with
1219634146
- labview与泰克示波器的pc通信编程流程图-Tektronix oscilloscope pc labview communicate with flow chart programming
1219634199
- labview与泰克示波器的pc通信编程流程图2-Tektronix oscilloscope pc labview communicate with the programming flow chart 2
12CT7
- 基于套接字和IEC61850协议的一个12路测试程序，可分别对12路状态进行设定，然后发送出去。-IEC61850 protocol based on sockets and a 12-test procedures, respectively of the 12-state set, then send out.
MY485
- 利用MFC编写的一个利用485通信的程序，在此程序中可对要发送的数据分别设定。-Using a MFC write the program to use 485 in this program can send the data to be set separately.
11
- 串口发送，上位机曲线实时显示接收到的数据-Serial transmission, PC curve data received real-time display
write
- protobuf wirte function.
Visual-CPPCommunication-Programming
- 通讯编程：网络通信协议分析与应用实现代码-Communication Programming: Analysis and application of network communication protocol implementation code