资源列表
XTalk
- XTalk网络通信程序改写版 可以实现网络通信功能-the modification of XTalk
sender
- 这是一个基于网络通信的网络会议的接受端。可以很方便的接受发送端发送的消息。-This is based on a network communication network conference JieShouDuan. Can easily accept the sender sends news.
NAT1.0
- c#写一个nat端口映射程序,可实现内外网的端口转换-c# write a nat port mapping procedures, can be converted inside and outside the network port
mscommj
- mscomm通信软件原代码,文件接受和mscomm接受.-mscomm communications software source code, documentation accepted and mscomm accepted.
shujuchuanshu
- 一个实现不同的数据传输的例子,很简单。主要用于初学者。-A realization of different data transmission example, very simple. Mainly used for beginners.
SWDC300A-2
- GPRS DTU使用说明，非常详细，不可多得-Instructions for use GPRS DTU
tongxinfangzhen1
- 对信号进行调制、并加入高斯噪声的基于matlab的通信系统仿真及分析。-The signal modulation, and add Gaussian noise communication system based on matlab simulation and analysis.
NetSender
- Using Net Sender Under Windows
tongxinfangzhen2
- 对给定语音信号进行抽样、量化和13折线PCM编码，经过传输后，接收端进行PCM译码，对此过程进行matlab仿真分析。-Given speech signal sampling, quantization and PCM 13 line coding, after transmission, the receiver for PCM decoding, matlab simulation of this process
tongxinfangzhen3
- 滚降系数为0.5的升余弦滚降系统的时域波形，二进制序列经过滚降系统后输出，画出输出端信号的时域波形和眼图。-Roll-off factor of 0.5 Raised Cosine system in time domain waveforms, binary sequence through the roll-off system after the output, draw the time-domain output signal waveform and eye diagram.
cmi_code
- cmi编码器：基带信号输入，进行cmi编码，对此过程进行matlab仿真。-cmi encoder: the input baseband signal, the cmi code, matlab simulation of this process
gps
- 利用广播星历求卫星在某一个瞬时的瞬时地球坐标系坐标-Using the satellite broadcast ephemeris request an instantaneous transient in a coordinate system Earth coordinate