资源列表
Elevator-Control
- 该PLC程序实现了对一套4层电梯上下运行的实际情况模拟，当系统运行时，该模块可自动显示电梯所在的楼层或当行运行的方向，具体实现的控制功能可参见压缩文件里的txt文档。-The PLC program to achieve the actual simulation of a 4-story elevator running up and down, and when the system is running, the module automatically show floor where
Digital-Frequency-Meter
- 该数字频率计使用EDA软件QUARTUS II编写，实现以下的3个功能： 1. 测试频率范围为：1Kz~99999999Hz， 2. 基准信号频率为1MHz； 3. 用8位十进制7段数码显示译码器显示所测信号的频率值。 -The digital frequency meter using EDA software QUARTUS II prepared to fulfill the following three functions: 1. Test frequency rang
radar1
- 合成孔径雷达 匹配滤波器 频域实现 三种脉冲压缩方式-Synthetic Aperture Radar achieve three matched filter in the frequency domain pulse compression
Xiaomi_Yi-Script-Autoexec-master
- Xiaomi_Yi scr ipt Autoexec-master
wave
- 海浪PM谱及波形的matlab仿真,并附有说明书，输入级数、采样数即可得到海浪。-matlab simulation of waves and wave spectra PM
GPC_lambda
- 时滞系统广义预测控制算法MATLAB仿真，不同控制加权矩阵控制效果对比-Generalized predictive control algorithm MATLAB simulation of time-delay systems, different control weighting matrix control effect of contrast
DMC
- 时滞系统动态矩阵控制算法MATLAB仿真程序-Delay system dynamic matrix control algorithm MATLAB simulation program
xilinx_uart_vhdl
- xilinx 公司的 串口 uart 源代码-Xilinx company the uart serial port of the source code
sliding-mode-control
- Matlab/Simulink 滑膜控制-sliding mode control
oqpsk2
- oqpsk调制与解调，包括星座图，误码率，awgn加入信道后的系统性能仿真-OQPSK modulation and demodulation, including constellation diagram, bit error rate, AWGN after the addition of the system performance simulation
GPS-acquisition-track
- 主要用matlab产生C/A码，并且捕获到信号，输出捕获结果和相位起始位置，而且可以实现对信号的跟踪，输出跟踪偏差和偏差震荡曲线，是一个很好很完整的GPS软件仿真的参考程序.-Mainly used matlab generated C/A code and capture the signal, and outputs the results of the capture phase starting position, but also can realize the tracking si
phase-change-UDF
- UDF for phase change process in ansys (fluent)