资源列表
adc0809
- 基于 80C52 单片机的 adc0809 模数转换 c程序，使用了IN0口，-Based on 80C52 microcontroller adc0809 ADC c procedures used IN0 mouth
c++ddfdddd
- 用c++写词法编译程序 -with France compiler c album with France compiler
Untitled
- 模拟单边带调幅及解调产生300 ~ 3400Hz的调制信号，画出时域波形及频谱； 产生载波信号，频率自定义，画出时域波形及频谱； 产生加性高斯白噪声，画出时域波形及频谱； 单边调幅，画出叠加噪声后的调制信号和已调信号的波形及频谱； 设计滤波器，画出幅频响应图； 解调，画出解调后的信号时域波形及频谱，并对比分析。-Simulation of single sideband amplitude modulation an
Log
- 用vbs编写日志、抓图、outlook发送邮件等可供大家学习参考-With vbs write logs, drawings, outlook to send e-mail and other information available to them to learn from
45666027ML
- ofdm的一种信道估计准则：最大似然信道估计准则-ofdm channel estimation as a criterion: maximum-likelihood channel estimation criteria
exception
- vc++6.0中的一个头文件，没有的话，将导致有些程序无法编译-vc++6.0 in a header file, not, will result in some programs can not compile
dynamic_programming_3_16_a
- 动态规划的程序（Kirk book）:A system is described by the first-order difference equation, find the optimal control values-Code for Kirk Dynamic Programming book 3-14 A system is described by the first-order difference equation, find the optimal control valu
i2f
- inter to float，整数转换为为浮点数-inter to float
points-file
- UG中批量保存点坐标到TXT文件的插件。保存出的点坐标的顺序与鼠标选择点的顺序一致。如果框选的话，保存顺序与点的建立顺序一致。-Auto-save of point coordinate in UG
decodeLogDomainSimple
- When the initial input falls between the Switch off point and Switch on point values, the initial output is the value when the relay is off.
decodeLogDomainSimple
- The on threshold for the relay. The Switch on point parameter is converted to the input data type offline using round-to-nearest and saturation. Switch off point-The on threshold for the relay. The Switch on point parameter is converted to the
f
- 读取场输出值，计算平均应力，并将读取的值和处理后得到的结果输出。-Read the output value, calculate the average stress, and reads the value and after processing the result output.