资源列表
嵌_ModbusTcpIp数据转发
- 昆仑通态屏与屏之间通讯，解决触摸屏之间数据交互的问题(Communication between screen and screen in Kunlun)
高斯噪声
- 仿真了高斯白噪声，并通过巴特沃夫滤波器生成高斯色噪声(The gaussian noise was simulated and the gaussian noise was generated through the butterworth filter)
polar
- Polar code with CA-SCL Decoder
毕业设计分布式MIMO
- 单小区理想模式下分布式MIMO建模以及能量效率计算(Distributed MIMO and energy efficiency)
ST7789-1-16BIT MCU
- TFT St7789V Spi 驱动代码(TFT St7789V Spi The driver code)
SecureCRT8.0
- 支持远程安全连接协议SSH1、SSH2、串口等。(Support remote secure connection protocol, SSH1, SSH2, serial port and so on.)
ex0
- 采用ch395实现TCP/IP，已测试过，可以用(Using ch395 to achieve TCP/IP, has been tested, you can use)
抓包
- GB28181 抓包，用于上下级对接调试(GB28181 package capture)
VB MbusTCPTest
- vb与PLC MODBUS TCP通讯。。。。。。。。。。。(VB communicate with PLC MODBUS TCP...........)
Optisystem中MatlabComponent模块的扩展应用
- 通过一个光相位调制器的实例，介绍利用Optisystem 中Matlab Component组件联合M atlab实现用户自定义光学组件的方法。对相位调制基本原理、相位调制器理论模型和实现模型的Matlab代码进行分析，介绍如何将用户自定义器件功能代码关联Matlab Component组件进行仿真，并利用自定义的相位调制器对理论分析进行验证。(Through an example of an optical phase modulator, this paper introduces the
MATLAB call OptiSystem
- 通过matlab的M文件调用optisystem打开OSD文件，并进行仿真，把数据返回到matlab画图。很实用，简单。OSD一定要用optisystem13版以上的才能打开。(Through the MATLAB M file, call optisystem, open the OSD file, and simulation, the data returned to the MATLAB drawing. Very practical, simple. OSD must use more
matlab瑞利衰落信道仿真(2)
- 在OFDM系统中的瑞利衰落信道分布，描述了信号进入信道前后的变化，误码率对比(The Rayleigh fading channel distribution in the OFDM system describes the change of the signal before and after the channel, the bit error rate comparison)