资源列表
MIMO_OFDMdexingdaoguji
- 多天线输入多输出技术正交频分复用技术结合,利用matlab仿真其不同信道估计-multi-antenna MIMO technology Orthogonal Frequency Division Multiplexing combination Matlab simulation using different channel estimation
LS_ChannelEstimation
- 基于MATLAB的OFDM信道估计算法，使用了PN序列作为导频，两种导频处信道估计处理方法，中间特别加入了相位估计处理-MATLAB-based channel estimation algorithm for OFDM using PN sequence as a pilot and two pilot channel estimation Department treatment methods, particularly the middle to join the treatment p
tcp
- 简单的网络通讯源代码..需要在java环境下运行,运行时需要先启动service,在启动客户端-Simple network communications source code .. need the java runtime environment, the runtime need to start service, the client at startup
BD_SVD_LIANGTIANXIAN_blast
- 基于BD-SVD分解的下行CoMP预编码算法仿真-Based on the BD-SVD decomposition of the downlink the CoMP pre-coding algorithm simulation
GMSK
- Matlab实现GMSK，包括基带信号，载波，和GMSK调制信号-matlab GMSK
final_gardner
- qpsk完整解调，包括载波同步，位同步采用迟早门，载波同步采用判决反馈-qpsk complete demodulation, including the carrier synchronization, bit synchronization using the door sooner or later, the use of decision feedback carrier synchronization
qpskgardner3
- 基于QPSK的位定时同步的gardner算法 Matlab-Of QPSK-based timing synchronization the gardner algorithm of Matlab
sc_fde_BPSK_removeCP
- 该序为2PSK的SC-FDE的系统程序，采用MMSE均衡方法-C-FDE system program, the sequence for 2PSK MMSE equalization method
main1MAX
- 终端直通技术，cellular用户同D2D用户间的资源分配-Device-to-Device，resource allocation
Untitled1
- 这是在MATLAB环境下实现ppm调制解调的程序代码-This is the code in the MATLAB environment ppm modem
mimo
- average.m为平均功率对信道容量的影响 WaterFilling.m为注水算法对信道容量的影响 主程序为天线相关性对MIMO的影响模拟-average.m average power of channel capacity WaterFilling.m channel capacity for the water-filling algorithm main program for the impact of antenna correlation on MIMO simulati
OQAM_IFFT
- 本代码介绍了OFDM/OQAM系统的基本的功能模块。发送端和接收端的调制与解调。-This code describes the basic functional modules of the OFDM/OQAM systems. Modulation and demodulation of the sender and the receiver.