资源列表
placecard_2.0.16
- Reading RFID tags with C# and RDM630
NEW+125RW简约版ID读写器
- NEW+125RW ID tools!!!
HXJ+T5557writer
- HXJ+T5557writer tools
rfid-master
- arduino的RFID库,智能门禁,可以用来读和写门禁卡(Arduino ide can run on three major operating systems: windows, Macintosh OS x, and Linux, while most other controllers can only be developed on windows.)
RFID_I2C_reader
- Arduino RFID over I2C Bus
ALOHA
- 实现动态帧时隙防碰撞算法,采用matlab语言编写,供大家参考使用。(The dynamic frame time slot anti-collision algorithm is implemented in MATLAB language for reference.)
NRF2401超详细中文注释
- nrf2401无线模块中文详细注释版C程序,逐条翻译(51单片机)(NRF2401 wireless module Chinese detailed annotation version of C program, one by one translation (51 single chip))
C++
- windows系统,c++语言的 通过RS232 (串口)操作RFID读写卡器的源代码(The windows system, the c++ language uses the RS232 (serial port) to operate the source code for the RFID read and write card)
2.STM32读卡号读写数据代码示例3.0(C语言)
- STM32单片机驱动RFID 读卡器的源代码 ,有原理图,有代码说明文件(STM32 MCU driver RFID reader source code, there is a schematic diagram, there is a code descr iption file)
51_M3650A
- STC11单片机驱动M3650A RFID读卡器的源代码,附带电路板原理图(STC11 MCU drives the source code of the M3650A RFID reader, and the schematic diagram of the circuit board)
STC89C52+RC522+OLED
- 此程序为RC522 RFID模块读写mifera卡程序例程,烧写后可直接使用(This program reads and writes the mifera card program routine for the RC522 RFID module. It can be used directly after burning and writing.)
Libnfc-CSharp-master
- libnfc in C#, almost 1:1