资源列表
CHAOLIU3
- 用于牛顿拉弗逊法的实际应用的用MATLAB编写的潮流计算程序-Used for Newton laffer method MATLAB prepared by the tide of the practical application of the application
fpga_vlog_src
- Hello i am new in this forum
EGS-model
- EGS模型的建立，通过模拟求解得到的结果。-EGS profile. Including EGS definitions, advantages and disadvantages, and research directions.
ADC
- 一段单片机采集三相电电压和电流的程序，大家可以下载研究一下-A single-chip three-phase power voltage and current acquisition program, you can download the study. .
3.2.5-gpio
- DSP2812控制电源信号采集和按键检测方案-DSP2812 embed-system
LambdaCalculator
- 计算管路阻力所需的雷诺数，可代替Moody图的查询。只需输入参数，程序会自动给出相应的判断结果。-Reynolds needed to calculate the pipeline resistance, can replace the Moody diagram queries. Simply input parameters, the program will automatically give the corresponding judge the results.
read-sgy
- 读写segy,对道头，工区的存储位置有详细说明-Read segy, right channel head, work area storage locations are described in detail
AVO-forward
- 第一类高阻抗含气砂岩AVO正演（自激自收）-The first class of high-impedance gas sands AVO forward
110021627
- 渗流力学中关于径向流阻力、产量的计算方法。-Seepage mechanics on radial flow resistance, yield calculation.
104
- 用于电力工程岩土工程勘察中高密度电法对采集数据的处理工作-Geotechnical investigation for power engineering of high-density electrical processing of the collected data
Protocol-conversion-program
- 本程序是专门针对Moxa的嵌入式计算机（LINUX系统版）写的，采用的是C语言，用于通信协议的转换即将串口设备转换为标准的Modbus TCP/IP协议! 默认的端口为502！本例运行平台是moxa的Uc7408-Lx-8上，上位机是IFIX，驱动为MBE！串口设备是一些电力仪表！ 要正确编译本程序，需要在Linux环境下，推荐采用Ubuntu！同时需要在Ubuntu上安装moxa的开发包，这个可以在其官网上下载！你只需要 简单的修改就可以用在实际的工程中！-This program
plane-anlsys
- 功能强大的平面应力求解fortran程序-good