资源列表
3busNR_try3
- Power Flow 3-Bus system using Newton Raphson
SlaveMbus_
- Implement Slave Modbus for PIC16F628 with function code 03 and 08
windows
- 在屏幕上开出三个窗口，它们的行列坐标（5,10）到（15,30）；（5,50）到（15,70）以及（18,15）到（22,65）。-Screen out three windows, coordinate their ranks (5,10) to (15,30) (5,50) to (15,70) and (18,15) to (22,65).
8051-programme
- 本專題是對於溫度、CO2設備來偵測，溫度、CO2經由熱敏電阻及MG811轉成電壓後，利用A/D 轉換電路將其訊號傳入8051，並顯示溫度、CO2濃度及設定值在LCD上，使其量測的溫度、CO2濃度數值大小能判斷目前狀態是理想，進而對其做加熱、冷卻及排氣的動作。-This topic is for temperature, CO2 equipment to detect temperature, CO2 via a thermistor and MG811 turn into a voltage,
Enhancement-homomorphic-filtering
- 采用傅里叶变换和数据矩阵平衡将同状态的波进行放大。 -Fourier transform and data matrix with the state of equilibrium will wave amplification.
ST7066
- ST7066 适用之前16*2的LCD 模块，这个文件能否直接移植就可以适用，非常方便，希望对大家有用。-ST7066 applicable before 16* 2 LCD module, this file can then be applied directly transplanted, very convenient, I hope useful.
3D-program
- 该程序是三维拓扑优化程序，对于做拓扑优化的学生来说是很有帮助的-matlab code for 3D topology optimization
top4inveter
- 此程序是柔顺机构的拓扑优化，以柔度最小为目标函数，以体积分数为约束条件-matlab code for compliant mechanism
L-ev-el-S-e-tM-ethod
- 该程序汇编水平集拓扑优化的GUI，学者可以通过人机界面进行结构的拓扑优化-lever-set
client
- 汇编源程序代码，一台机器和你一台机器进行通讯，一台机器是上位机，里一台机器是上位机，上位机可以接受上位机发送过来的数据，并且使控制台上的灯亮- Compilation of source code, a machine and a machine you communicate, a machine is the host computer, where a machine is a PC, the PC can accept data sent the host computer, an
tranficlights.txt
- 两个方向的交通灯程序，包括红黄绿和数字计时，完全符合显示交通灯。-Traffic lights in both directions, including the red yellow and digital timing display in full compliance with traffic lights.
READ-EEPROM
- program for testing of ic24c02 microcontroller used 8051